2008 Ford F-350 Super Duty Logo

Related Topics:

k
katlatigo Posted on Feb 09, 2014

The steering wheel audio and cruise controls on my 2008 F350 super duty quit working.

My audio and cruise controls on the steering wheel don't work. The horn works and so does the temp and fan controls.

5 Related Answers

Anonymous

  • 1392 Answers
  • Posted on Jul 10, 2009

SOURCE: '94 Ford Econoline (RV)... cruise control and horn

You need a new clock spring assembly.

Ad

Philip Armitage

  • 437 Answers
  • Posted on Oct 02, 2009

SOURCE: the horn and cruise control doesn't work,fuses are

the horn input to ground is located in the cruise control module. if they both don't work then your cruise control module or the clockspring coil for the steering wheel needs to be replaced. If airbag lights is on as well then I would change the clockspring coil first.

afairman1927

  • 41 Answers
  • Posted on Feb 16, 2010

SOURCE: ford f350 horn and cruise control quit working,

It is most likely a part called a clockspring. It is located behind the steering wheel. When that part is defective you will almost definitely lose your horn, airbag, and cruise control. If it is not that it is probably corroded at the harness located on the steering column or at the cruise control module in the engine bay. If you have tilt, which you probably do, those wires can become frayed at the plug or directly after the plug at the column. I would start with fuses, then wires, then clockspring.

Anonymous

  • 400 Answers
  • Posted on Jan 03, 2011

SOURCE: My horn and cruise control are not working, could

Most of the time your horn and cruise is on the same fuse....Should be a 15 or 20 amp

Anonymous

  • 22 Answers
  • Posted on Dec 02, 2011

SOURCE: Ford f250 super duty V10 cruise control doesn't work.

WOULD CHECK BRAKE SWITCH FIRST AS THESE HAVE A HIGH FAILURE RATE.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer
0helpful
1answer
0helpful
1answer

2000 ford f350. Niether the emergency flashers or turn siganls work. Intermittenet problem. Either it all works or none of it works. Cruise control also quit about same time, but is not intermitent>...

It sounds like you have a problem with the combination switch ( or also called turn signal switch ). To get to the flasher pull the heater control switch or the radio out and the flasher is on the left side, it might have a black cover on it
0helpful
1answer

I am not getting any power to my cruise control. It's not activating at all. Everything else works though. What do I need to do?

If it is on the pad in the steering wheel and you have checked the fuse, its more then likely the pad. These are known for problems on fords.
6helpful
1answer

2008 Ford F350 diesel crew power steering locks up & breaks dont work while driving for short moments

Power steering fluid is full? Sounds like it might be a power steering pump. It has hydroboost brakes that are controlled by the Power steering.
9helpful
1answer

Ford f350 horn and cruise control quit working, whats the problem?

It is most likely a part called a clockspring. It is located behind the steering wheel. When that part is defective you will almost definitely lose your horn, airbag, and cruise control. If it is not that it is probably corroded at the harness located on the steering column or at the cruise control module in the engine bay. If you have tilt, which you probably do, those wires can become frayed at the plug or directly after the plug at the column. I would start with fuses, then wires, then clockspring.
0helpful
1answer

2004 F350 Diesel - Cruise and horn don't work

First check all the fuses.
I suspect the problem is in the steering column, if it was just in for repair for the brake switch, I would start by checking the connectors for the steering column under the dash as this is close proximity to where the brake switch would have call home.

If this is not the case then there are contact rings at the base of the steering wheel that allow contact for the horn and cruise control buttons, the wheel would have to be removed to check these.

Start with connectors and fuses as these are simplest.

Hope this is of some help.
Ed
0helpful
1answer

Cruise control stopped working

Check to see if theres a Recall on the Cruise control cut-off switch on the master cylinder.. If so.. replace it asap.. It causes fires.. even with keys out they suddenly erupt.. try that first and lemmie know.. Thnk you
2helpful
2answers

IM TRYING TO FIND THE CRUISE CONTROL FUSE AND FUSE BOX LOCATION ON A FORD F-350 2006 SUPER DUTY TRUCK AUTOMATIC.

the fuse panel is under the plastic panel on the left of the steering wheel, the cruise does not have a deicated fuse, it is controlled by the powertrain control module, if the truck runs the cruise has power, the most common cause of the cruise being inop is he rotating contact under the steering wheel, it is called the clock-spring contact
Not finding what you are looking for?

295 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...