1989 Toyota Camry Logo

Related Topics:

A
Anonymous Posted on Feb 05, 2014

Where is ecm located in 1988 toyota camry - 1989 Toyota Camry

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Jul 24, 2008

SOURCE: locating fuel filter in toyota camry 1988 model

i found the fuel filter under the bonnet next to & behind the air filter!

Ad

Anonymous

  • 57 Answers
  • Posted on Jan 04, 2009

SOURCE: toyota 1988 camry

Egr Valve is usually attached to plenum with a tube that runs to exhaust minifold. If you dont know what those things are then. Find the black tube that runs from the front of the car to the front of the motor. there should be a big square box where you air filter goes in the middle of that tube. Well where that tube connect on the front of the motor. That is called the throttle body. the big block of aluminum is called the plenum. Bolted to that plenum is going to be a space ship looking thing that has one rubber hose a wireing plug that plugs into it and a long tube that is attached to the bottom that goes down behind the motor to your exhaust. There should be 2 or three nuts or bolts that hold it in place. Sorry if I overexplained this but I do not know how much you know about the car......Good luck!

Anonymous

  • 412 Answers
  • Posted on Nov 14, 2009

SOURCE: fuel filter location for a 1988 toyota camry

gonna be right on the firewall towards the driversside of vehicle.....or pass side on firewall...one of the two places

Anonymous

  • 962 Answers
  • Posted on Nov 18, 2009

SOURCE: my 1988 toyota camry: airconditioner/heat doesn't work

The heater may not work because of a bad thermostat, low coolant, or a bad sensor at the engine. It can also be a bad resistor valve under the dash. The resistor valve is connected to a wire plug on the blower motor under the dashboard. It needs to be replaced. Th AC may need to be refilled with refrigerant or the compressor may be bad.

Anonymous

  • 143 Answers
  • Posted on Jun 06, 2010

SOURCE: 1996 toyota camry termostrat location

should be located where the lower hose meets the engine block inside that unit

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Where is all the fuses located in a 1988 Toyota camry

Fuses for lights, radio, etc is located on the kick panel just to the left of the clutch. Difficult to see and reach so you have to get your head right down by the pedals. Fuses for things like the fuel pump, etc are located under the hood usually towards the front of the car on the drivers side.

Best to you.
0helpful
1answer

2002 Toyota Camry overdrive fuse

It isn't a fusible item, it is a function of the Engine Control Module. You need an auto electrician for issues and to diagnose faults.

https://fuse-box.info/toyota/toyota-camry-xv30-2002-2006-fuses-and-relay

2002 Toyota Camry 2.4L - ECM ECU PCM ' 89661-3T171

Flagship One https://www.fs1inc.com > 89661-3t171-2002-toyota-c...

This Engine Computer also referred to as an Engine Control Module (ECM), Engine Control Unit (ECU) & Powertrain Control Module (PCM)

..
0helpful
2answers

Diagram for 1988 Toyota camry power window switch

I have the same issue, I can't find anything online for the location of the power window relay or the circuit for the power windows.on a 1988 Camry. Either the internet is lame or the 1988 Camry is truly bullet proof, where there are no people that ever had the same problem where it would be posted online and we could find it with ease
2helpful
1answer

Ecm location and illustration, please

FOr 1994 Toyota Camry 2.2L EFI DOHC 4cyl the Engine Control Computer is located: Front seating area, passenger side, under dash, mounted behind kick panel.

102cb0a.jpg

Components locations-1MZ-FE engine (click for zoom).

I hope helps (remember to rate this).
1helpful
1answer

Fuel filter location for a 1988 toyota camry

gonna be right on the firewall towards the driversside of vehicle.....or pass side on firewall...one of the two places
1helpful
1answer

No ignition fire

The wiring harness routing is critical on this car.  Any incorrect routing, and a short can easily develop.  If you took some photos before, and as you did the work - perhaps you can check the routing. The route of the main harness behind the Throttle body and each cylinder's main intake port - is critical.  I've owned a 1988 Camry since new.  Pulled the engine out and replaced the timing belt several times. (Just found it easier.)  Once, I got the harness routed just a little bit wrong, then the car drove for a few miles and quit.  Turned out to be a little rub spot had shorted a wire - killing the fuel pump.  Just a tiny spot - took a long time to find...  Before throwing more parts at the car - check carefully and very slowly for any open rub spots in the harness.  If you have a source - verify wire routing...  Good luck.

FYI: The Coil in the 1988 Camry is located in the distributor.  It is easily checked with an ohm meter.  Generally, doesn't go out.
0helpful
1answer

CAMRY TOYOTA 1988

www.alldatadiy.com
this is a great resource for info
normally 17.00 a year but if you enter this code its only 9.99 for the first year. ADR2763
0helpful
1answer

Locating fuel filter in toyota camry 1988 model

i found the fuel filter under the bonnet next to & behind the air filter!
Not finding what you are looking for?

310 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...