My 2003 crysler sebring stalled and want start back I geting the camshift sensor code I replaced it and car still wont start and still geting the code Would the timeing belt casue this

asdasdasdasd

there are 15 or more sensors on it,Depens on how it is equip.

is the check engine light on??
i've done a few that had no light/codes.the most common problems are crank or cam sensor failures. really need to check when car stalls.
replacing crank sensor 6 mths ago & car has'nt had a problem. if you search these sensor on the sebring you'll find alot of info.

did you bleed fuel lines

Try substatutting the ignition module with a known goog one.Also have the camshaft CIRCUIT checked at the camshsft sensor plug in, for propper voltage.The code P0340 indicates a circuit malfunction not a sensor malfunction. Good luck.

code 40-
Possible causes - 1/1 And 2/1 O2 sensors harness circuit shorted
- 1/1 And 2/1 O2 sensors harness circuit connectors (wrong connection)
- Faulty Powertrain Control Module (PCM) P0040 CHRYSLER Description At ignition on the Powertrain Control Module (PCM) checks the voltage on the ground side of the O2 sensor harness connector. If voltage is higher than two volts the P0040 code will set. code 41- Possible causes - 1/2 And 2/2 O2 sensors harness circuit shorted
- 1/2 And 2/2 O2 sensors harness circuit connectors (wrong connection)
- Faulty Powertrain Control Module (PCM) P0041 CHRYSLER Description At ignition on the Powertrain Control Module (PCM) checks the voltage on the ground side of the O2 sensor harness connector. If voltage is higher than two volts the P0041 code will set.

The MAP sensor does the same thing as a TPS Throttle position sensor Tells computer at what angel the intake butterfly is at non fixable Replace the part

Crank sensor is dead get a new one have it replaced/ Cam sensor controls gas / Crank sensor controls Spark

Crank Sensor is the likely issue. It does not throw a code. Key indicator is the call stalls all the time. R&R sensor.

they are right these two sensors will out out time in the computer so replace your cam sensor.