- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
https://fuse-box.info > cadillac > cadillac-cts-2008-2009...
Here you will find fuse box diagrams of Cadillac CTS 2008, 2009, 2010, 2011, 2012, 2013 and 2014, get information about the location of the fuse panels inside ...
You've visited this page 2 times. Last visit: 19/11/22
the auxiliary is an electric pump and whereas the main water pump is mechanical, this works after you turns the engine off and keeps you warm in winter after the engine is turned off, and you have the key turned to accessory. In summer it helps a gradual cool down of the engine. ..
https://fuse-box.info > Home > Cadillac
Fuse box diagrams (location and assignment of the electrical fuses and relays) ... of electrical fuses and relays) for Cadillac CTS (2008, 2009, 2010, 2011, ...
My 2009 CTS4 should be the same as your 2008 CTS. There is no dipstick tube to check or fill the transmission. The check plug is in the bottom of the pan. It loos like a drain plug, but it is not. The fill plug is on the passenger side of the transmission, just above the front of the oil pan. It is a plastic and rubber plug that is pulled straight up.
You'll probably be better off having it checked and filled at a dealer or trans shop.
YOU NEED TO REMOVE FLYWHEEL REMOVE OIL PAN. REMOVE REAR OIL SEAL HOUSING BOLTS. USING THE PRY POINT LOCATED AT THE EDGE OF THE CRANKSHAFT REAR MAIN SEAL HOUSING SHEAR THE RTV SEALANT. REMOVE THE REAR MAIN OIL SEAL. INSTALL GUIDE PINS INTO THE TWO CRANK SHAFT REAR OIL SEAL HOUSING CORNER BOLT HOLES OF THE ENGINE BLOCK.INSTALL THE CRANKSHAFT REAR SEAL INSTALLING TOOL ONTO THE REAR OF THE CRANKSHAFT FLANGE. APPLY A 0.2 INCH 3MM BEAD OF SILICONE SEALANT TO THE REAR OIL SEAL HOUSING . INSTALL THE REAR HOUSING TO THE ENGINE BLOCK.REMOVE THE GUIDE PINS AND INSTALL THE HOUSING BOLTS TIGHTEN THE BOLTS TO 89 INCH LBS. REMOVE THE REAR SEAL INSTALLATION TOOL FROM THE CRANKSHAFT FLANGE.THEN INSTALL OIL PAN AND FLYWHEEL.
The Location of the oil filter depends on which engine you have in your CTS. the 3.2 engine the oil filter is located on the bottom of the engine to the left of the oil pan. It is not a screw on type filter it is a canister filter. You will have to unscrew the lid to gain access to the oil filter. On the 3.6 Engine the oil filter is also a canister filter but it is located on the top side of the engine. On the drivers side around the center of the engine cover. It will take a 15/16 socket to remove the lid.
×