I loss my remote control of my 1997 toyota vienta

Toyota Camry (1999 - 2000) - fuse box diagram - Auto Genius

www.autogenius.info > toyota-camry-1999-2000-fuse-...

Jul. 30, 2016 - Toyota Camry (1999 - 2000) - fuse box diagram. Year of production: 1999, 2000. Engine compartment. Toyota Camry - fuse box - engine ...

Fuse Box Diagram Toyota - Fuse-Box.info

fuse-box.info > toyota

Fuse box diagram (location and assignment of electrical fuses) for Toyota ... of electrical fuses) Toyota Camry / Vienta (XV20; 1997, 1998, 1999, 2000, 2001).

Drop by a dealer and they will run your serial number and tell you if recalls have been done or needed on your vehicle.

have a pressure test done on the coolant system to find the leak. check the engine oil to see if it is milky or grey. Have a compression test done to check for head gasket fault or cracked head.

Your central processor is erratci and givng into wrong commands. Start from exiting one by one from the battery of the remote to the main hand rest., Check for poor connection in the wiring harness specially in the areas of the door hinges where the wires go into the customer control.Also try to find out if any moisture or oil has clogged on to the main Unit.
Hope you have patience.

To give you a simple answer, no. My advice is to take it to an A level technician for diagnostics. Sounds like you could have some sensors misreading.

Hi,

That engine will leak oil from

- cam cover gaskets (rear one drips on the exhaust)
- camshaft end seals
- distributor shaft o-ring (appears on top of transaxle housing)
- oil filter bracket to block o-ring seal (drips on front bank exhaust)
- crankshaft nose oil seal (have done with timing belt change)
- rear main seal (expensive, leave it be)

1-insert and remove key from ignition two times

2-close and open driver door two times

3-insert and remove key once from ign.

4-close and open drvr door twice

5-insert key into ign.,then close driver door

6-turn key to on (not start) then off, twice this is rewrite mode,have all remotes to reprogram it will clear any lost remotes.

7-remove key from ignition,the door locks should cycle twice.if not start over.it may take a few tries.

8-press lock/unlock together and hold for a second

9-release,and press lock on remote,the door locks will cycle confirming program.continue to do other remotes you have,steps 8 and 9.if only one in possession,you are done. To end mode open door or insert key into ignition.

You'll need to follow the steps with no more than a 1-2 second delay between each step.. hope it works

You need to replace the window regulator assembly.
The cables that run the glass up and down have broken inside the regulator.

Hope this helps. A FixYa rating would be greatly apprecited.

12 ) is engine speed R.P.M. sensor circuit
52 ) is knock sensor circuit
54 ) is turbocharger intercooler control - coolant too low
hope this answers your question and remember to rat all solutions you get, thanx.

No, not true. We replace remotes regularly, and have never had a need for a "working" remote. The keyless entry system does not "disable" itself. Hope this helps.