SOURCE: 2001 mazda sunroof
Please click on this link:
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152801a7b5d
Good luck...
SOURCE: mazda 2003 MPV door locks
I just fixed this same problem. It happened to me 3 different times in
a month so I got good at it. Before you dive into removing your door
try this. Pull the door handle and release it letting it snap back
several times. The problem is a half open door latch that won't let the
door unlock. Do this as aggressively as you can to attempt to get the
latch to return to its original position. Check the door lock between
flicks.
Ok, if that didn't work, here is how to remove the door.
1. Remove the screw behind the door latch, you will have to pop the plastic cover off first.
2. Remove the rubber insert in the door handle
3. Remove the screw that is now visible
4.
Now remove the window/lock control module, the back is free but the
front has a plastic lip so lift the back up and pull towards the back
of the van.
5. Remove the clips that attach to the lock and to the window controls (these can be a pain)
5. (Optional) Remove the bracket that held the window/lock control module
At
this point your door is basically free, it is only held in place with
plastic clips that can be easily forced off. If your door were open you
would simple pull the bottom of the door out (hinged at the window) and
lift it off. But since we can't pull because the door is closed we have
to force it out.
From here it is pretty simple. Move the seat
all the way back and tip the seat way back. Lift the door panel
straight up. You will be breaking 2 plastic clips from the rear part
but once you do it just pulls out. This is not that easy because the
space is limited but just keep pulling and force the rear end of the
door panel past the b-pillar. Once you do this it is free.
Have fun and try to keep the black gook from getting everywhere.
Oh, to fix the door lock just oil/grease it and manually move the mechanism several times.
SOURCE: Mazda 5 replacing external handle on sliding door
Your door should be held on with clips. Removing the panel is sometimes hard, just take a good WIDE flat head screwdriver, and whatever tool needed to remove the screws holding the panel on, and be careful. Check underneath the panel, by the inside handle, and the arm point for screws. Once removed, take your WIDE screw driver, and don't quite pry them off, more or less try to get it underneath and pull towards yourself. There is no real easy way, just try to be patient with it, and if you hit any binds, look for more screws, its just a matter of patience for sure.
SOURCE: program remote control for mazda mpv 2002
Courtesy of: forums.mazdaworld.org
Try this, it works on several 2002 models:
Step 1: Open drivers door and leave open.
Step 2: Lock and unlock the drivers door using the power door lock switch on the door.
Step 3: Insert key into the ignition.
Step 4: Turn key to on position and return to off position. (IMPORTANT
- use ON position NOT ACC position). Do this 3 times within 10 seconds.
Leave key in the ignition.
Step 5: Open and close the drivers door 3 times. (Door should be left open after this step).
Step 6: ECU should respond by locking and unlocking the doors.
Step 7: Press any button on remote #1. ECU responds by locking and unlocking the car doors.
Step 8: Press any button on remote #2 (etc.) Each time the ECU will respond by locking & unlocking the doors.
Step 9: Remove the key from the ignition and the ECU will respond a
final time with a series of door locks and unlocks. You're done
274 views
Usually answered in minutes!
×