SOURCE: 93 buick park ave Ultra. replacing water pump
Yes. Put a jack under the motor and remove 3 bolts from side of engine and the long center pivot bolt in mount and the 2 bolts that go top down into the frame and loosen the 2 bolts below mount. Jack up the motor until you can separate the mount, leaving the engine side in and removing the frame side. The engine side can be moved out of the way without completely removing.
Testimonial: "answered the question completely and thoroughly!"
SOURCE: 1994 buick park ave, wont crank over,
Pass key is the security system which disables the car if it is stolen. You need the remote or a key with a chip to start the car. go to a dealer, prove ownership with registration and they will be able to help you out
SOURCE: i have a 1998 buick park ave ultra and the driver
assuming you have an electronic controlled (digital) dual zone system, it is most likely your heater blend door motor has failed, check and see which side is operating and buy the one you need and replace, it has 2 or 3 screws on the side, i think size is 4.5 mm or 5.5 mm and you have to take off lower plastic cover under dash and remove screws which go on horizontally... install heater door with temp swithched to the middle, move door to middle, if not you need to place new motor into plug before installing and turn temp to cold, then turn by hand the white blend door tube to match motor then install... make sure you turn off ignition when working,,,
342 views
Usually answered in minutes!
×