SOURCE: power seat issue
Get out your voltmeter, unplug the connection to the seat's motor, underneath the seat, and hit the switch. if youve got power going to the motor then youll need to replace the motor. If not, it's probably the switch. Also make sure the wires are not cut or damaged somewhere between the switch and the seat.
SOURCE: programming a 1995 toyota avalon key fob
To program a remote... note that you must not delay more than 10 seconds between any of the operations.
Driver's door open, all other doors closed, key removed from the ignition switch.
Insert key into ignitions switch, then remove it.
Press LOCK then UNLOCK on the vehicle door lock control switch at 1 second intervals 5 times.
close and re-open drivers door.
Press LOCK and UNLOCK on the vehicle door lock control switch at 1 second intervals 5 times
Insert Key into ignition switch.
Switch ignition ON and OFF once to program a remote transmitter code while retaining the original codes or twice to program a remote transmitter code while erasing the original codes. three times to check how many remote transmitters are currently registered, or 5 times to erase all registered codes.
Remove Key from ignition switch.
System should now lock and unlock vehicle. Once, twice or five times depending which mode has been selected. It will lock and unlock one to four times slowly, to indicate the number of remote transmitters registered if you chose option 3.
Press and hold remote transmitter LOCK and UNLOCK buttons at the same time.
Press LOCK remote button for 1 second: System should now lock and unlock vehicle once to confirm, twice to indicate registration has failed.
NOTE: to exit programming mode, close drivers door or insert key in the ignition.
NOTE: a maximum of 4 remote transmitters can be programmed
SOURCE: '96 Toyota Land Cruiser (LX 450)- Power Seats won't go in reverse
Well what I saw when I pulled my seats out of my 97 LC was that the worm gear on the bottom of the track had lost some tread. (its plastic) also, there is a cap that screws in to the end of that gear to hold it in place, so when you reverse the seat, the gear moves if that cap falls out of place ----small plastic cap fell out in mine. The whole rail system is like $300 at Toyota but i found a website that sells the cap and the gears for $20. I will try to post it tomorrow-for the time being, you can take the seat out -be sure to unplug the electronics, and use a wrench to manually move the seat back and then put it back into place
SOURCE: drivers seat wont move forward. power moves the
try tapping the motor that runs the seat back and forth.sometimes the motors get corroded if they are not used often enough.
SOURCE: 2003 Toyota Camry drivers side power seat stuck
This is not necessary...as many have stated...use a hammer with switch in reverse position. Hammer the seat back...it will catch...
http://schematicsdiagram.blogspot.com/2011/12/replacing-power-adjustable-bucket-seats.html
-------------
Volvo
Seat Removal with Heated Seats?
http://schematicsdiagram.blogspot.in/2012/07/volvo-seat-removal-with-heated-seats.html
-------------
How to Remove Rear seat on Rover 600?
http://repairhelpcenter.blogspot.com/2012/01/there-are-3-10mm-bolts-at-back-of-seats.html
---------
How to remove Seat?
http://repairhelpcenter.blogspot.com/2011/11/how-to-remove-seat-on-acura-integra.html
-----------
These will help.
Thanks.
290 views
Usually answered in minutes!
×