It's located by oil filter,may have to remove filter to remove switch,may need a stubby(short) wrench to remove,may be able to turn tiresout to get to,it's a tight fit.Remove electrical connector,then get wrench and remove,then take to Autozone and match up with new one,here it is. Duralast Oil Pressure Switch PS561 2006 Nissan Datsun Xterra 2WD 6...
SOURCE: remeove rear combination tail light cover 2006 Nissan XTERRA
I just changed out a tailight on my 2000 Nissan Xterra, so I assume it may be similar. You have to pop the plastic strip which runs across the back. There are pop rivits in it.
SOURCE: oil pressure needle at H
sounds like an oil pressure sening unit un plug it whilf its running and see if the gauge goes too zero,if not then the prob is the gauge, the sending unit is only about 15.00 at auto zone and easy too put in
SOURCE: remeove rear combination tail light cover 2006 Nissan XTERRA
thode screws hold the lens or the light assembly? Allow for the whole tail light to come out and the bulb plug will be accessible. I never had the privilage. But how the lens fits will tell you. If the lens goes overthe edges, the whole unit comes out, lens is sealed. Good luck
SOURCE: HOW TO REPLACE A FUEL PUMP FOR A NISSAN XTERRA
Removal & Installation
Negative battery cable
Fuel pump module harness connectors
Filler hose shield
Fuel pressure and return lines
Filler hose
Vent hose
Evaporative Emissions (EVAP) hose
Fuel tank skid plate
Fuel tank
Fuel level sender
Fuel pump
To install:
Fuel pump
Fuel level sender. Tighten the screws to 17-23 inch lbs. (2.0-2.5 Nm).
Fuel tank. Tighten the bolts to 27-36 ft. lbs. (37-49 Nm).
Fuel tank skid plate. Tighten the bolts to 27-36 ft. lbs. (37-49 Nm).
EVAP hose
Vent hose
Filler hose
Fuel pressure and return lines
Filler hose shield
Fuel pump module harness connectors
Negative battery cable
SOURCE: xterra no oil pressure
inner timing cover y shaped oil gallery gaskets..make your own or order the complete cover..costs from nissan are 500 canadian for the cover and around 1500 total for the replacement.oil pressure goes back up immediately after the install..alot of work to replace a cheezy piece of paper...
506 views
Usually answered in minutes!
×