The starter is fine and the battery is good..push started it and it started..when rpms were low engine stalls,,,wont crank up again..any solutions?
Well, to accurately determine the problem as fast as possible you could perform a ECU diagnostics.
Located Here: http://www.nicoclub.com/articles.php?id=249406
Other than that - here is what i would check and verify using the FSM (Factory Service Manual)
Located here: http://300zx-twinturbo.com/cgi-bin/manual.cgi
Things to check:
Check to make sure your using a key that doesnt have any bends/damage (could trip a security issue)
Check Battery Cables for corrosion
Check for any possible wiring shorts
Check the resistance in the starter (Could have a good starter, but not properly grounded)
If what i recommended didnt help, check the ECU diagnostics, it's very easy to perform and will give you an exact description of where to look for your problem =) If you need further help (same goes for anyone) email me at [email protected]
Best Regards,
Kyle
Check you nozzles and the oil filter
176 views
Usually answered in minutes!
when you try 2 start do you hear a click if so the starter isnt getting enough power replace your main cable.
×