SOURCE: Remove and replace 1994 Toyota pickup starter
disconnect battery ..remove skid plate..remove battery/ignition wire from starter (2 nuts)..remove starter bolts(2 )
SOURCE: How many bolts are on the starter motor for a
I was able to do this whole job easily without crawling under the car. I did not even raise the front of the car. I did not need a helper to hold the starter, it just came out and I lifted it thru the top against the firewall. (had to remove a sensor or two and the whole air cleaner housing and air intake thing.) The nut holding the cable to the starter was 13mm not 12mm Make sure to place a drop light under the starter and use a mirror. It makes the job so much more enjoyable.
SOURCE: How many bolts are on the starter motor toyota
There are 2 bolts retaining the starter to the transaxle. Please make sure that you disconnect the battery wires before you remove the starter wires
SOURCE: where do i find the
First, do not keep driving if the oil warning light is on or your oil pressure gauge has dropped. Stop the engine, let it sit for a few minutes, then check the oil level.
If the dipstick shows a full oil level, then low oil obviously isn't your problem. The oil pressure may be low because of a worn or broken oil pump, a plugged oil pickup screen in the engine's crankcase, possibly a plugged oil filter or excessive bearing wear. Or, the oil pressure may be fine but the oil pressure sending unit has failed. Further diagnosis will be required to determine what's wrong.
Perform electrical tests on oil pressure switch http://www.clarks-garage.com/shop-manual/elect-19.htm
Replace pressure switch as the cheapest means of repair to see if the lights go out .
The pressure switch will be located on the engine block.
191 views
Usually answered in minutes!
×