SOURCE: Buick LeSabre left front window will not close
Don it. Good half day for amateur. Get Chilton 86-99 Bonneville, 88, Lesabre manuel.. Tricky to find bolts are under end flaps on door close handgrips. Took me a day to figure that one out. Others under light at lip of back of door. Book indicates to strart with window 3/4 up if you can. Flip up window control at rear of panel. After all screws are out raise outer edge of armrest and look for notches 4" and 11-1/2" from rear of armrest to slide inward to remove. There are screws under the door handle too. Screws everwhere. When pulling bottom of panel from door lift with a notched bar to avoid tearing the fasteners out of the cardboard panel. Two screws behind seatbelt notch at top need to come out to allow positioning the glass. The panel at the bottom of the top opening can be removed for more fredom in positioning the glass when reinserting the ball in the lower track on the window. Tape glass with duct tape to keep it from falling. Drill the factory rivets that hold the old regulator and I replaced with stove bolts with nylon locknuts slotted head to the inside the car. Can't remember the size, probably 1/4 or 3/16". Remove speaker if in front bottom of door to use your hand to do work in the door. You must twist the regulator forward with window 1/2 down to remove the ball from the socket in the bottom sliding metal track at the bottom of the window. Don't drop the window after removing the socket, tape it in place. Don't know what you do if you cannot move it to 1/2 up position. By the way, the body shops say you must use rivets, not screws or it will shift, but I have had no problems with the screws for reinstallation several years old. The rivet they use take a big hydraulic pop rivet gun that you won't have. Good luck, I don't envy you. Need to do other window on my 91. The window control may not be the same on the Custom, mine is the Ltd. you may be able to remove the motor from the regulator in the door without removing the regulator if you can figure out how to get the bolts that hold the moter to the regulator. inside the door.
SOURCE: To program the keyless remote for a 1998 Buick
under drivers side dash, with small wire or paper clip.
SOURCE: Can the DIC be used to read OBD-II codes on a 2004 Buick Lesabre?
No sorry, Take it to autozone, they will scan it for free.
SOURCE: Fuel relay placement 1991 Buick LeSabre. Replaced pump & filter still won't start
Your vehicle's fuel pump relay is located on the relay center, behind the glove box, 2nd column of relays, 2nd one from the top.
SOURCE: 1991 buick Lesabre,ignition switch key will not turn to off posit
Spray the beejesuz out of the inside of the tumbler/keyhole with WD40...replace the key and try again...Otherwise an ignition assmbly might be available through a junkyard?
good Luck
82 views
Usually answered in minutes!
×