Ignition won;t start. The key insert is loose and turns but won't start

PRIZM.

wont crank or?

cranks fast, but will not start.?

did you try jump cables start? off a running donor car, AAA style>?

and had to disconn? what does that mean and what was results? if any.

ahhh, to fix the stuck on blinkers? i get it.

not to fix starting...



blinkers on , key off>?

that?

which engine?

http://www.fixkick.com/PRIZM.html



the engine type dictates what wiring car has. (partly)



fix the stuck blinkers first. this implies, either ignition switch failure

or gross wiring errors, hacks gone wrong.

the key swtich does turn off blinker power feed.

The remote starter module is not getting an electrical signal when you turn the key to the on position after remote stating the vehicle. When you depress the brake without turning the key on the vehicle shuts down. The remote module thinks the key is off even when you turn it on. There is a loose connection or the remote start device is defective.

There might be a ground wire loose or any of the positive wires coming off the battery might also be loose or coroded. That can also be part of your prior fuse problem. If its the same fuse that blows, that could be where your entire problem existes.

Sounds like the shift cable has broken

Sounds like the ignition switch is worn out(or the linkage from the lock cylinder to the switch has come loose or something like that)

could be something with the automatic combined the stift shift

are your wheels turned to either side against a curb where you cant turn the steering wheel? if so you need to force the steering wheel a little further to get the key to release

There has to be 12 volts in system for the key to release its electrical for it to release

pull out negative terminal battery located under rear right seat.wait for 5 min n then install again the lead negative terminal.insert the key to ignition cylinder.turn the key on off three times.now start the engine.make sure u use recommended fuel grade.

I had the same problem and once I wiggled the shifter enough to get it out of park then the key stuck in the ignition started.