I was changing the spark plugs and noticed they had oil on them
Do you mean oil on the spark plug points, the gap? Or oil around the body and the threads?
Testimonial: "oil around on the body,of plugs and threads."
not the points
not the points of plugs.
Ok, the tube which forms the spark plug well in the middle of the cam cover has an oil seal on it, like an o-ring. To replace these you will need to remove the cam cover, and renew that gasket too on replacement. For best results I'd use genuine Toyota parts as I have found the aftermarket gaskets go hard fairly early.
×
SOURCE: how much oil do i put in a 4.7l V8 toyota tundra 06?
6.5 quarts and then check it after running it a bit and shut down for 5 minutes.
SOURCE: changing spark plugs in a 2004 toyota 4runner
check www.4x4wire.com i was just there looking for the same thing and found step by step directions on how to do it
SOURCE: My 2007 Toyota Tundra 4.7l shows VSC OFF lights
check air filter for dirty , how many miles or kms have your car? , maybe need to replace spark plugs, try to reset the ecu for a momentany malfunction, remove the negative battery terminal few minutes and reconnect,start engine and drive, check if lights goes off , please write me
SOURCE: change spark plugs on 2007 Toyota Camry
In servicing the spark plug . If the owner will be the one to change the spark plug then. the owner should locate the spark plugs . then prepare the equipments that is going to be used to change spark plug .First disconnect the spark plug cable to the spark pug . Then use the equipment to take the spark plug off to the engine. The spark plug should be twisted counter clock wise using the equipment to remove the spark plug.Then replace the spark plug.In returning the spark plug ,using the equipment you have to twist the spark plug clock wise . Then set the distributor shaft turn it according to the proper firing order that will be set to the spark plug if it is 1,3,4,2. Then the distributor shaft mark will be on 1.If 2,3,4,1 then the distributor shaft mark will be on 2. Then connect the spark plug cable , after connecting the owner have to test start the car so that to if it back fires .If it back fires then the owner have to repeat again the setting of the firing order of the spark plug until it will not back fires.If the owner don't have time to do the job in servicing or changing spark plug then the owner have to go to a car mechanic and let them change the spark plug.
430 views
Usually answered in minutes!
×