Lighting wiring diagram needed for HID/DRL install/disable

David Gibbons

• 26 Answers
• Posted on Jan 31, 2009

SOURCE: 2002 Pontiac Grand Prix Thermostat

as you face the engine the thermostat bell is on the right (drivers side) Follow the radiatoe hose. Remove the two bolts and raise the bell still attatched to the hose. the thermostat is there with the rubber seal. You can gently pry the thermostat out with a screwdriver or something similar. Put in new thermostat be sure it is the same as the old one, and then replace or change the seal (be sure it is the smae size and thickness as the old one as I got the wrong size from Napa) Then replace the bell, and tighten, but not over tighten. I hope this helps!

SOURCE: hi and low beam headlight wire colors

i used a test light to test each wire with lo beams on only 1 wire caused the test light to light up then when i turned on the hi beam the other wire lit up the yest light and the 3rd wire was just a common ground

SOURCE: Fog Lamps on 2003 Pontiac Sunfire Not Working

check ground at fog lamps.

SOURCE: How to disable the daytime running lights 2004 Subaru Outback LLB

Sorry to inform you, but I have been trying to solve this problem for a customer of mine who is in the military. Subaru will not release any information on how to do this.

Bruce Bracey

• 1000 Answers
• Posted on Aug 18, 2009

SOURCE: putting in a daytime driving

I have 3 mechanization's that illustrate the components and the wire color for the DRL system of you vehicle. If you have an e-mail address I can forward them to you.
I will display them below, but they may not be legible in this format.
Let me know.
Regards,

Testimonial: "A man worth talking to!"