2004 Toyota Corolla Logo

Related Topics:

A
Anonymous Posted on Jan 11, 2014

Corolla 2000 vvti throttle body hose diagram - 2004 Toyota Corolla

1 Related Answer

scottyoung56

Scott Young

  • 91 Answers
  • Posted on Jul 03, 2009

SOURCE: toyota corolla 1.4 vvti cluth problem

try to give it a little gas when letting the clutch out

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

Where is the throttle body located? How do we clean the throttle body?

Throttle body is located where the hose from the air filter box meets the engine. Big black hose. Remove this hose from the engine side and this will be the throttle body/plate assembly. If it is black/oily inside, clean with carb spray and a toothbrush to remove any dirt/deposits
0helpful
1answer

I am missing a vacuum hose that plugs in just below the throttle body on my 2000 Wrangler 2.5L. Which hose is this and where does it go?

its laying around the engine its a black vacuum hose . in some models they dont use that connection an the connector is capped over with a rubber cap
1helpful
1answer

How to replace thermostat on 2005 Corolla

Hi Chuck !
You can find the solution here. Hope this help you.

How to replace thermostat Toyota Corolla. VVTi engine. Years 2000-2008.

How to change Thermostat Toyota Corolla. VVTi engine. Years 2000-2008.youtube.com
0helpful
1answer

Toyota hilux vvti 2.0 does not rev. I have cleaned up the throttle body and still does not rev.

NO YEAR?
scans good, no stored or pending DTC codes>????????
dirty MAF, (if MAP EFI, clogged map port?)
low fuel pressure>?
bad need of simple tuneup?
1helpful
1answer

Replacing thermostat need diagram

V8 behind throttle body -follow radiator hose

V6 in hose on driver side, about middle of engine
at the front
12helpful
2answers

Looking for a pdf. of vaccuum hoses on a 2000 focus

SPI Vacuum Diagram
spivacuumiy9.jpg

Zetec Vacuum Diagram

zetecvacuumtz6.jpg user_offline.gif SPI Vacuum Diagram
spivacuumiy9.jpg

Zetec Vacuum Diagram

zetecvacuumtz6.jpg user_offline.gif spivacuumiy9.jpg

Zetec Vacuum Diagram

zetecvacuumtz6.jpg user_offline.gif If it's equipped with the 2.0L SPI engine (eighth digit of the VIN is 'P'), the most common place for a vacuum leak on these engines, is from the PCV hose that runs from the valve cover to the back of the throttle body. Where it usually rots through is the elbow at the back where it connects to the throttle body. Hope this helps. The only place i could find any views is here. vacuum hose diagram - Focus Fanatics
1helpful
2answers

I cannot locate the throttle position sensor on my 2000 catera

THERE IS NO CONVENTIONAL TPS, THROTTLE POSITION IS PART OF THE DRIVE BY WIRE SYSTEM IN THE THROTTLE BODY ASSEMBLY
0helpful
1answer

Rough idle blazer 2000

change air filter.clean throttle plates.remove throttle body remove all electrical parts also all plastics and rubber parts.clean throttle body with gum out throttle body cleaner.dry off throttle body.replace gasket.scan it to check to see if egr valve leaking.also check all vacuum hoses.and pvc valve.
0helpful
2answers

Need a diagram / blueprint of the location to the throttle position sensor to a cadillac cetara 2000

on the side of the throttle body where the air intake hose hooks to the engine from the air cleaner. see photo of sensor

fe936f7.jpg.
Not finding what you are looking for?

286 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...