2001 Volkswagen Jetta TDI Logo

Related Topics:

A
Anonymous Posted on Dec 07, 2017

My epc light is on

Epc light on after fuse blows in inside fuse panel replace fuse light goes out but when engine is turned off a small pump or motor of some type under the hood which has cooling system (heater type) hoses connected to it continues to run til fuse blows or battery dies most of the time this is a 2001 vw jetta vr6 engine

5 Related Answers

Anonymous

  • 1263 Answers
  • Posted on Sep 24, 2008

SOURCE: 2002 V.W. Jetta 2.0 liter overheat

turn your heater on to max heat and high fan. then see if you can feel the hoses on the firewall for heat they should be hot. make sure that the fan unit on the radiatoris working if the upper radiator hose is hot the fans should be running if they are not that means that either the relay is bad the thermo sensor is bad or the fan unit is shot... please rate the solution..........thanks

Ad

Anonymous

  • 1066 Answers
  • Posted on Mar 12, 2009

SOURCE: OVER HEATING

In the fan circuit...You have a temp switch screwed on the radiator, a fuze and a relay in the fuze box plus a fan.  Swap the relay with another relay, replace the fuze.  The other fan should come on when the a/c is turned on.  If you fix the fans and it still overheats, you may have a BLOWN HEAD GASKET.  ALSO ARE YOU BLEEDING THE AIR FROM THE SYSTEM?  DO YOU SMELL EXHAUST IN THE COOLANT?   

Anonymous

  • 2 Answers
  • Posted on Mar 25, 2009

SOURCE: check engine light and epc

I have an 03' 1.8 T GTI with just over 100k. EPC and Check engine light was on... got it fixed it was the Engine Speed Sensor cost $450.00 to fix!!!!!!!!!!!!!!

Anonymous

  • 4669 Answers
  • Posted on Mar 28, 2009

SOURCE: Instrument panel gauges all stopped working while driving.

These vans are common for having cracked circuit boards in the Instrument cluster. You need to replace the circuit board. Try smacking the end of the dash and see if the gauges start working again.

Anonymous

  • 2050 Answers
  • Posted on Dec 19, 2009

SOURCE: 2001 vw jetta hood won't open. Faulty latch

They are not designed to open from the outside. Why can't you get inside?

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have a 2003vw jetta the epc light is on and the will not come out of park nor the stop lights come on,I have already changed the brake switch and still won't work..

EPC light should have nothing to do with the shift interlock,(EPC is traction control) should be a small cap or plug on the console, near the shifter that has the interlock disengage button,usually done with a key,check shift interlock in the owners manual.
0helpful
1answer

Does a 1994 Chevrolet Silverado c1500 have a fuel pump

Yes, it has an electrical fuel pump located in the gas tank. First check the fuel pump fuse located in the fuse panel on the left outer side of the dash. You can only access this panel with the driver's door open. It is located near the black button for the dome lights and chime.

It is a 20-amp fuse. Replace it if it is blown, but ONLY with a 20-amp fuse. The wire harness for the fuel pump sometimes goes bad, or the pump motor, or the wire harness inside the tank to the pump motor. If the blown fuse is replaced with a larger-amp fuse, you could cause a fire or explosion.

If it blows the replacement fuse, stop. Fuses blow for a reason, 9 times out of 10. Call a tow truck to remove the truck to a qualified repair shop.
0helpful
1answer

Check engine light goes on after I rev engine. when rpm is low light comes on. why?

Dear friend. This issues appears when we have a fuel pump problem. I had the same issue. When the fuel pump pressure is low, the eletronic injection control send a sign for EPC control to blink the engine ligth. With rpm hight you increase the pressure automtic due to hight rotation motor applied on the fuel pump. To solve it, change the fuel pump, check if you have any hose blocked with dirt and so on. Afterthat verify the eletronic injectors nozzles and the timing belt position.
Hope to help you.
Regards.

Erik Weide
0helpful
1answer
4helpful
1answer

Code 410

code po410 on a 2004 gmc envoy is that there is a problem with the secondary air injection system, you will need to check the fuse located in the engine compartment first, the next step is to start the truck cold and listen for the air pump to turn on for a few seconds, this will sound like a jet engine but not that loud, after it runs for 5 min and you dont hear it then you may have a bad pump which is located under the driverside on frame but if you hear the pump then you may have a bad valve, this valve is located on the exhaust manifold area and has a hose from the pump to valve, remove the hose and check for water, drain any water in the hose, also remove hose at pump and drain, the most common cause for this code is the valve is not opening and the air pump gets water inside and goes bad, thats the po410 code. a quick note; if fuse is blown look under truck near pump and check relay as it fills with water and blows fuse, if this is the case replace relay and blow water out of connector.good day.
2helpful
1answer

Car bogs down epc light comes on, then goes off car runs then normally, I replaced mass air flow, front and back 02 sensors, but continues to bog and epc light goes on and off

epc is short for electronic pedal control, the throttle is controlled by an electric motor and has two angle sensors in the throttle body. the pedal it self has two sensors as well, sometimes after a battery replacement or replacement of certain parts (ecm throttle body pedal controls) the control modules need to be reset or "relearned" to one another. the dealer or independent shop with correct softwear can do this, if problem persists possible bad throttle body pedal sensors or ecm (engine control module)
0helpful
1answer

I have 97 ford mustang gt v8 4.6 engine as i was driving home one day my car died check the 20amp fuse that was blown and small 30amp under the hood. replace the fuse blown again crank the car up the theft...

The twenty amp maxi fuse in the under the hood fuse panel goes to, you guessed it, the fuel pump. It sounds to me like you have a short to ground in the wiring that keeps popping this fuse. Find and fix the short, or you will keep blowing fuses.
1helpful
2answers

Air bag light is on 96 grand caravan

i may be mistaken on if this applies to your model year but if the rear wiper does not work then check the fuse for rear wiper and replace if blown. make sure rear wiper switch is off and wiper is parked.if air bag light goes out after a few seconds then the rear wiper motor is bad causing fuse to blow. air bag module gets power for its fuse through wiper fuse.if wiper is not parked then fuse may blow when you turn yhe key on.you have two choices. replace wiper motor or remove tailgate door panel and unplug the motor
0helpful
1answer

1986 RV blows instrument panel fuse when switch pulled

The headlight switch has a rheostat built into it to dim your dash lights, it may have shorted out. As soon as you turn on the switch this rheostat comes into play and is probably whats blowing the fuse. I think if you replace the headlight switch, it will solve your problems.
Not finding what you are looking for?

145 views

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Bradley
Bradley

Level 2 Expert

105 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...