Replace 2008 tiburon starter - Tiburon Hyundai Cars & Trucks

Question edited for clarity, add maker and correct order.

Clutch Replacement Without Removing Sub-Frame

Hyundai Tiburon Forums https://www.newtiburon.com > ... > Transmissions Jan 22, 2021 - Briansmobile1 on YT put out a video detailing how to do a clutch job without dropping the whole subframe on a Sonata. Our subframe is supposedly ...

Clutch Install ' Hyundai Tiburon Forums
May 16, 2010
How much to replace clutch? - Hyundai Tiburon Forums
Apr 1, 2008
Installed clutch without dropping subframe
Feb 11, 2007
How long should a clutch repair take? - Hyundai Tiburon Forums
Nov 26, 2012
More results from www.newtiburon.com
..

If your unsure, follow the battery cables from the battery to the starter motor, it's held in with 3 bolts I believe, about 30 mins work, if in doubt get someone to help you with it.

You just go to the link I attached I'm sure you will get the solution of your problem -

HYUNDAI TIBURON COUPE 2002 2008 WORKSHOP REPAIR MANUAL

HYUNDAI TIBURON COUPE 2002 2008 WORKSHOP REPAIR MANUAL

get your car fix right now

if you are going to treat your car like it is garbage,take it to a mechanic

If you try to start the car but only hear a clicking sound when turning the key, then its the selinoid. Replace it. Located as a small tube housed next to the starter motor. Starters can be overhalled depending on its internal condition and if it is not a sealed type. Replacing the bushes and brushes.

Removal & Installation

Specific to:
Hyundai Entourage 2007-2008

1. Before servicing the vehicle, refer to the Precautions Section.
2. Disconnect the negative (-) battery terminal.
3. Remove the crash pad lower panel (A).
   
   
   
   Fig. Remove the crash pad lower panel (A)
4. Remove the 2 screws (A) and the trip switch connector.
5. Remove the crash fascia panel (B).
   
   
   
   Fig. Remove the crash fascia panel (B)
6. Remove the screw with the ignition in the ON position (IG ON) and disconnect the 6P connector.
7. Remove the ignition switch (A).
8. Installation is the reverse of removal procedure.
   
   
   
   Fig. Remove the ignition switch (A)

Specific to:
Hyundai Accent 2006-2008
Hyundai Azera 2006-2008
Hyundai Elantra 2006-2008
Hyundai Sonata 2006-2008
Hyundai Tiburon 2006-2008

1. Before servicing the vehicle, refer to the Precautions Section.
2. Remove or disconnect the following:
   
   The negative battery terminalThe crash pad lower panelThe ignition switch after loosening the screw with IG ON and disconnecting the 6P connector
3. Installation is the reverse of the removal procedure.hope this helps it is off autozone website

need alternator.... perhaps? or most likely a blown fuse...which is an inexpensive fix

yeah i'm having the same problem

hood vent door vent give me more specifics or go to collisionrepairadvice.com and go to information page