Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on Feb 27, 2018

Key fob Will not lock-unlock doors, but pops trunk

I have 2 fobs, new batteries in both and they both are doing the same think. Door locks work fine on the car (door switches), just not on either remote? so, cant be the remotes, is there a sensor on the car that is only for the doors that could be out? Any help is GREATLY appreciated!

1 Answer

kelly

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Master:

An expert who has achieved Level 3.

  • Pontiac Master 616 Answers
  • Posted on Feb 27, 2018
kelly
Pontiac Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Master:

An expert who has achieved Level 3.

Joined: Feb 23, 2015
Answers
616
Questions
3
Helped
180302
Points
1917

Your key fobs need to be reset to the car alarm again u tube how to set fob to you car , keep in mind if you have a 95 car it may have been made after july of 94. you may need to use the year before if your year don t work

5 Related Answers

Anonymous

  • 324 Answers
  • Posted on Nov 26, 2008

SOURCE: Audi A4 Y Reg 2001, Central locking

reset you computer, do this by removing the positive battery cable for 10 mins.

Ad

Anonymous

  • 2 Answers
  • Posted on Apr 21, 2009

SOURCE: 2002 Dodge Grand Caravan Driver Door Lock/Unlock Switch

sorry not sure the 12v prob will help this swtich works on 5v off 3v unlock 1v lock single wire lock/unlock logic signals
I found wiring diagrams at
http://www.dodge.com/bodybuilder/2004/docs/wd/rswd/tc.pdf
it is 2004 but use the wiring diagrams to test the wires
(most likely to fail where they flex)
because it is using logic gates disconnect the plug at each end of the wire you are testing or the damn thing will find a few diffrent ways to trick you.

Steeler Ed

  • 130 Answers
  • Posted on May 02, 2009

SOURCE: Remote door locks don't work with both keyfobs unless it is in the car

Replace the battery in the key fob and try again. That's the number 1 problem solver for this.

Anonymous

  • 306 Answers
  • Posted on Feb 08, 2010

SOURCE: neither key fob is working to open the car with

open door. when alarm goes off put key in ignition and turn it on start car. this should disarm the factory alarm.

Anonymous

  • 4793 Answers
  • Posted on Jun 11, 2010

SOURCE: mk 4 golf, remote key not locking/unlokcikg doors?

unlock with key and hold key over for 30 secs(windows may go down)then lock with key and hold over for 30 secs(windows may go up)then press remote unlock button and hold for 30 secs,you have just reset system...the closer you have to get to the car for the remote to work the lower the battery power.sensor on top of dash(little black dimple)rarely,if at all, goes wrong.....

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Key fob dont work, but door lock works ok, key fob battery change.

1. Get in your vehicle.
2. Close the door.
3. Put key in ignition
4. Do not turn on the ignition yet.
5. Hold down on the unlock button on the door panel. Do not let up.
6. Turn the key to ON, OFF, ON, OFF (while still holding the unlock button on the door panel).
7. Release the unlock button.
8. The door locks should cycle, indicating that you did everything correctly.
9. Have all your remote entry fobs available. Hold down on both the lock and unlock buttons until the door locks cycle. Do the same on all key fobs. This will re-program all of them.
10. Turn ON the ignition key to exit the program mode.
11. DONE.
0helpful
1answer

Jeep liberty 2006 power lock will lock but not unlock

there are 3 ways to lock.
key metal
on door switches
and the FOB, RKE.

so is this a fob question? key fob? only failure???????
did you know that many fob modes are PROgrammable?
the operators guide tells you how to do that.
did you try both fobs, that came with car new., if not why not?
did you replace the 8 year old fob batteries, no , why not now.?

on my 08 (for example) :
can program it to only open drivers door. or all.
and autolock feature off or on.

on my other car all was worked fine. then drives door failed
to open (all 3 fobs fail, one is new) the door solenoid was bad.
$100 part. now fixed, by me.
so do all fobs fail. if in fact this is a FOB question
RKE (called remote key entry by jeep)

i have 4 fobs for my jeep now. you must have 2 good keys.
to make a 3rd by self.
so keep 2 , never ever used. to be self sufficient.
this is not a door issue, above 3 lines, its a not getting stranded issue.


0helpful
1answer

2002 buick century key fob problem

Sounds like the remote receiver module in the car is malfunctioning and will probably need to be replaced.
0helpful
1answer

1999 porsche 996 replaced key fob battery disconnected battery now trunk releses are locked and cant access battery.How do you open frt trunk manually

Assuming the car battery is ok (if not, buy a male to male cigarette lighter at the auto store and connect to another car until charged enough to unlock the doors...but don't try to crank the ignition!). The trunks won't open if the battery went dead with the alarm set because arming the alarm physically locks the releases.

Sounds like the key code is switched off because you replaced the key fob battery. Try unlocking the car manual with the key in the door lock. Then switch the ignition on to reactive the keyless entry. If this does not work, you might also try pressing the fob unlock button with the key in the door lock until the dash led flashes.
6helpful
4answers

My Porsche Key fob no longer unlocks the doors

Insert key into door barrel or ignition lock and turn key, whilst doing this press the unlock/lock button, the led on the dash should flash to indicate this has initialised the key to the car, then remove key and test operation of remote. If this fails then a new remote plus coding to the car by your dealership is needed
0helpful
2answers

But a used 2006 solara but key fob does not remotely open trunk. Any suggestions?

Yes, insure that you have power to the trunk lock inside trunk, If not could be lose/broken wire or shot fuse. I am sure the key fob does work for the doors? If not have key fob battery replaced. Also, a quick check on power to trunk lock, check to see if have remote power button inside car, if it works power is good. Defective key fob would then be indicated.
1helpful
1answer

Car will not unlock.

To get inside the car .... Use the key in the lock cylinder, unlock the drivers door to get inside. You shouldn't have to reprogram the fob unless it or the keyless module was changed. There may be a blown fuse that supplies the keyless control module (check the owners manual for location). or wires that lead into the Drivers door may be damaged ... The keyless module is located inside the drivers door at the bottom behind the door panel ... do the unlock/lock and trunk release switches on the inside of the drivers door operate the locks and or trunk release? If so it is not the fuse ... and not the wires to it ... And it could be your BCM body control module, located in the dash board to right of your gas petal. Because the number entry keypad (code for that is on the inside of the right passenger trunk bracket arm) also doesn't work I assume it's not the key fobs themselves. Your 98 manual is correct for your car.
4helpful
2answers

Lincoln Continental2000-Door key won't unlock door-but starts car

I locked the 2000 lincoln continental with the key fob but lost it now the ignition key wilolo not unlock the door
Not finding what you are looking for?

1,526 views

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...