SOURCE: Toyota Corolla VE 1999
Ok ,Is there red LED lite in the car for the alarm system? if it's an after market alarm there could be a bypass switch under the drivers panel that you could of hit accidently that would put the system into a valet mode . this switch would put the system into a door lock and unlock mode only. So look under the driver's dash or side kick panel for a switch or button, you would need the car on to switch it back
SOURCE: Trouble changing tires for '99 Toyota Corolla
Sounds like the wheel is just rusted to the hub a little bit. Take all the lug nuts out exept for one. Leave the last one on about half way. Make sure the vehicle is sturdy on the jack you are using and that the car is park(or gear for manual) and have the emergancy brake set.. Now if you have a heavy dead blow hammer you can give the wheel a healthy wack from behind, or you can turn your back to the wheel and give it a donkey kick at the bottom of the wheel. The last lug will keep the wheel from flying off at you. Now dont be alarmed about the wheel not turning, if this is a front wheel you are trying to turn, you shouldnt be able to turn it becasue the car is either in gear or park. Good luck and let me know if it works out okay
SOURCE: Security light is on after the key is turn off in
THAT IS HOW IT IS DESIGNED TO SHOW U THAT IT IS TURNED ON. AND WHEN U CLOSE THE DOOR IT BLINKS TO ACTIVATE SECURITY. NOT TO BE RUDE BUT ALL THIS I BELIEVE IS IN YOUR OWNERS MANUAL IF U WASN'T NOT GIVEN ONE ASK YOUR DEALER FOR ONE THANKS
SOURCE: where is reset button and how do you do it to
i have an 07 Toyota Tacoma and the tire exclamation light reset button is located on the dash board under the steering wheel. The button says "set". This is what it says to do in my pocket reference guide for my truck. It says "If tire pressure becomes critically low on any of the tires (including spare), indicator comes on. Pushing "(***)SET" button should not turn off the light. Correctly adjusting tire inflation will turn off the light after a few minutes. After replacing/rotating tire or wheels, push and hold (***)SET" button until the indicator blinks three times.
Hope this helps you
JAK Kingston
SOURCE: how do i reset my 2010 Toyota Tundra TPMS (Tire Pressure Monitoring System)
the sensor needs to be programmed to the vehicle by a dealer or tire store like firestone
154 views
Usually answered in minutes!
×