Question about 1993 Chevrolet Lumina

Open Question

Oil filter location on a 1993 chevy lumina

I need to locate where the oil filter is on a 1993 chevy lumina

Posted by Anonymous on

Ad

5 Suggested Answers

co7196

Ned C Cook

  • 3433 Answers

SOURCE: 93 chevy lumina crank sensor location

front of engine just about 11:00 over crank pullry

Posted on Jun 12, 2009

Ad

brodychurch

  • 13 Answers

SOURCE: where is the oil filter located on 1993 chevy

its on the drivers side of the engine about half way down

Posted on Jul 08, 2009

Ad

Anonymous

  • 33 Answers

SOURCE: Location of 1993 Chevy Lumina temperature gauge

If you follow the top radiator hose from the radiator to the enigine you will see a wire connecting to a screw in like plug. This screw in a the temperature sending unit. Disconnect the wire that is going to it and you should be able to unscrew the plug with a socket and ratchet. Be careful to do this when the engine is cold or you run a high risk of coolant spewing out and burning you. You sill lose some coolant even when it is cold but you shouldnt lose enough to have a problem with the coolant level. After you change it run the car and check the resevoir to make sure you didnot lose to much.

Posted on Apr 16, 2010

Norman Green

  • 312 Answers

SOURCE: where is the oil filter located on a 1993 chevy

look by the front driver side fender inside the engine compartment. it's not on the engine but on the fender.

Posted on Oct 20, 2010

MrTehPenguin

  • 1 Answer

SOURCE: where is the egr valve located on a 1993 chevy

If it's the 3.1L then it should be on the intake manifold on the drivers side toward to the rear of it. If not then it should be on the upper intake and the firewall right in the middle. Hope this helps!mrtehpenguin.jpg Should look like this ^

Posted on Mar 07, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I locate crankshaft position sensor 1993 Chevy Lumina Euro


3.1 vin T
3x sensor firewall side of engine above oil pan between transmission
24x sensor behind crank pulley/ balancer

Jan 27, 2014 | 1993 Chevrolet Lumina

1 Answer

1993 chevy lumina will not idle


check fuel filter if this doesnt resolve your problem do a fuel pressure
test !!!!!!!!!

Feb 03, 2013 | 1993 Chevrolet Lumina

1 Answer

1993 chevy lumina-tps


"TPS" stands for Throttle Position Sensor. It is located in the same place that all TPS sensors are located - on the throttle body.

Apr 14, 2012 | 1993 Chevrolet Lumina APV

1 Answer

Trying to find where the oxygen sensor is on a 1993 chevy lumina 3.1


Yes the o2 sensors are located on the exhaust manifold and down the exhaust its self.. 1993 there might be only 1 o2 sensor but could be 2.

Feb 04, 2012 | 1993 Chevrolet Lumina

2 Answers

What weight oil do I put into my 1993 Lumina?


With an older engine you need something of low viscosity when cold and high viscosity when hot and that is also resistant to mechanical shear forces. Try some branded (Mobil etc.) fully synthetic 5/40 multi-grade. Fully synthetic oils do not need to be changed nearly as often as the older traditional engine oils. Given the extended periods over which these oils can be used they possibly work out cheaper than using more frequently changed traditional (cheaper) oils. Always renew the oil filter when changing oil.

May 24, 2010 | 1993 Chevrolet Lumina

2 Answers

I have water on the floor boards of my Chevy Lumina.The seals around the doors and windows are not wet,and there is no water trail running down the door panels.What could be causing the water on my floor...


clean out under the front cowl.there are drains that come out of the firewall.probably plugged up.the water backs up and runs down through the blower motor.

Feb 10, 2010 | 1993 Chevrolet Lumina

1 Answer

Where is oil pressure switch in chevy lumina van 1996?


To locate the oil pressure sending unit, locate the oil filter and look above it and to the right, above the starter. You will see a long round sensor, this is the oil pressure sending unit. It screws into the engine block and when you remove it you will get a dribble of oil.

Jan 23, 2010 | 1996 Chevrolet Lumina Mini

1 Answer

How hard is it to replace the starter on a 1993


Not that bad, jack up front of car used jack stands, starter sit between radiator and engine, on engine block above oil pan, disconnect battery 1st.

Jan 08, 2010 | 1995 Chevrolet Lumina

2 Answers

How do you remove starter?


disconnect neg batt cable. as required remove nuts from a/c compressor and eng brace, adjacent to starter, if neessary. remove nut from eng cross brace. using a pry bar between upper eng mount and eng pry rerward and support eng.if nessary remove oil filter, air induction tube and cooling fan. Disconnect wiring at starter, and (note!!!!)position. good luck

Jun 25, 2009 | 1993 Chevrolet Lumina APV

1 Answer

Where is the oil filter located on a 1993 Chevy Lumina Minivan V6?


it is in the fron of the van between the motor and radiator fan

Nov 28, 2008 | 1993 Chevrolet Lumina APV

Not finding what you are looking for?
1993 Chevrolet Lumina Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...