When the weather is very cold. My door looks will not work. I'm able to torn the key, but nothing happens. but the car will start once I'm in.
SOURCE: 2005 ford taurus. Remote entry wont work theft light keeps blinking when key is engaged
HI, I'm reading your problem,
Let me explain something about your car.
2005 Ford Taurus, The key on that car has Chip inside of the key and receiver on the ignition switch,
Check if the key you are trying to use is Black and has a plastic head.
If not you need a key with that characteristics.
But if you have the right key, Remenber if you had drop on the floor, or hit with something,
Because some times they come damaged, with insignificat thins.
Remenber if you left the key close to a magnets like speakers.
If nothing aply at your case, you need to call a place Aloha Smith, they have the computer to program or reprogarm your key. IF not you can't start your car.
OK.. I hope this information work for you.
Thank's for submit yous question on fixya.com
SOURCE: 2005 cadillac sts remote transmitter
This is the procedure for a reprogram of the remote's from the factory service manual, if it doesn't work then u may have a receiver issue.
Use this Procedure for Vehicles with
Driver Information Center Buttons
This information is in your Owners Manual in the
Drivers Information Center Section.
1. Insert Key and turn to ON position so you can access Driver Information Center
2. Press the vehicle information button until
PRESS TO RELEARN REMOTE KEY displays
3. Press the set/reset button until
REMOTE KEY LEARNING ACTIVE displays
4. Press and hold the lock and unlock buttons on the first keyless remote at the same
time for approximatley 15 seconds. A chime will sound indicating that the remote is
programmed.
5. To program additional remotes at this time repeat step 3.
This vehicle can have a maximum of eight remotes programmed.
6. To exit programming mode turn key off and remove key.
Test remote(s).
Use this Procedure for Vehicles without
Drivers Information Center Buttons
To access this display, the vehicle must be in Park (P) with key in the on position (as far
as you can go without cranking engine)
1. Press the trip odometer reset stem until RELEARN REMOTE KEY displays.
2. Press and hold the trip odometer reset stem for three seconds.
The message REMOTE KEY LEARNING ACTIVE will display
3. Press and hold the lock and unlock buttons on the first keyless remote at the same
time for approximately 15 seconds. A chime will sound indicating that the remote is
programmed.
4. To program additional remotes at this time repeat step 3.
This vehicle can have a maximum of eight remotes programmed.
5. To exit programming mode turn key off and remove key.
Test remote(s).
SOURCE: Power door locks dont work
hello on the door locks not working could be a couple problems open the driver side door and were the door hinges are there is a small tube with wires in there that runs from the door into the side of the kick panel inside of the car these wires are your windowns locks and more now were the door open you will have to cut tube with a razr knife so you can see if any of the wires are broken now if there is no wires broken now the power door lock actuators inside the front right-and left door could be bad or the door look swiches this is not unlikey you can check this by removing the door panel you will see a rod or cable going from the door lock down the bottom of the door
now on the key not working that sounds like the door lock rods there that hooks to the lock on the inside of the door is off or one of the plastic clips that hold the rods has broken if it is not locking or unlocking your doors it is not unlikey for both sides to be broken you will have to remove the door panels to check
SOURCE: 2001 Chevy Impala won't start
If the battery has gone dead, it could cause the security system to go into full lock-up mode. If it has locked up the accessories will work after the battery is charged back up , but the power to the starter will be cut off and it wont turn over. You need to do the 30 minute learn procedure. A GM dealer will print it out for you and you can do it yourself. It's very simple if you follow the procedure exact. hope this helps and good luck.
SOURCE: e39 starting issues
HAVE YOU HAD THE BATTERY TESTED? ARE THE BATTERY TERMINALS/CABLES CLEAN AND FREE OF CORROSION? ARE THEY TIGHT?
39 views
Usually answered in minutes!
×