SOURCE: ABS WARNING LIGHT ON VOLVO V70 1997
ABS light comes on with ignition then should go off when you start the car.
If abs sensor does not turn off after disconnecting the battery, then
there is a real problem, a faulty sensor or ABS malfunctioning.
When the ABS led comes on immediately after you start the car and stays on usually is one of the relays.
The main one is called surge arrester relay, if it is faulty usually there have been an
overvoltage.
There should be two more, usually located behind the black plastic cover of the ABS.
Testing and changing the faulty relay can fix the problem.
If light turns off on startup, and comes back on when you reach some
speed, usually you need to check the wheel sensors. You test them
unplugging the sensor located behind the wheel and testing it for
continuity with a multimeter.
Use Haynes manual to find locations and specs of relays.
Contact a qualified mechanic if you cannot fix it yourself, problems with ABS may compromise safety of the vehicle.
SOURCE: mazda tribute abs fault. abs
These vehicles have a recall on the ABS system for faulty wiring. You may want to check with your local dealer to see if your vehicle is included.
SOURCE: Whistling soung from engine
Take a look at the belt see if it has cracks or worn grooves.. if it dose have it replaced. if it doesn't pull on the belt back and forth see if the tension pully is giving the belt tension( it supposed to be about 1/2 of an inche to an inch or try to turn the belt around to almost half way) if not replace the tensioner pully. if good check the free pully by starting the car and spary a bit of wd40 on the center of the pully if noise disappers replace the free pully. if not see ur local auto shop..
SOURCE: speedo and abs light on bmw 5 series
hello , it sounds like you have a bad speed sensor or all 4 of them , see when the speedo plays dead like that is because (most cases ) the sensors at the wheels are bad due to water and normal driving corrosion , the data for the speedo comes from the abs module that monitors the sensors if the abs does not reed it the speedo will not reed it aswell , it will be good to scan the vehicle to see if you need more than 1 sensor there is one in each tire axel ,good luck
SOURCE: Peugeot 106 1.0 litre, temperature warning light
hi, if the collant level is ok and the car isnt over heating then check the heater works in the car and make sure it gives of heat when hot is selected if it dont then the chances are the thermostat has gone and needs replacing.
If on the other hand you have heat then the chances are its just a faulty temp sensot these are cheap to buy and easy to replace.
Let me know how you get on or if you need further assistance ok
On vehicles equipped with antilock brakes (ABS), a second warning light is provided to warn if a problem occurs within the ABS system. The ABS lamp comes on when the ignition is turned on for a bulb check, then goes out after the engine starts. If the ABS warning light remains on or comes on while driving, it indicates a fault has occurred in the ABS system.
What happens next depends on the nature of the fault. On most applications, the ABS system disables itself if the ABS warning light comes on and remains on.
103 views
Usually answered in minutes!
×