FOB(for entire vehicle) and Right front door (power window and lock) stopped working at the same time. It's not the FOB as my spare also doesn't work. RF window and lock will not work from drivers control panel or at door. I suspect a fuse but can't figure out which one it would be.
SOURCE: Driver Side Window won't work- Chevy Blazer 2003
If it does not make any noise, or sound like its getting any power, most likely its the switch.
SOURCE: power door locks and drivers window have failed on 2004 colorado
I had the same problem to the T. I look online for all the same solutions and I can only tell you what worked for me. Actually what I think worked, HAHA! I went out to my truck and unplugged both battery terminals from battery and placed them together to supposedly reset the electrical system, "so I was told." After this for about 20 min or so, I went back out and in this order; re-installed positive terminal followed by negative terminal to battery. After this I checked locks and windows and surprise they worked. I've seen a lot of people say that all they did was wait and they worked later, so maybe it was that and not what I did, but who cares, they work now. Give it a shot and if it works for you, GREAT let me know, I HATE CHEVY CAUSE OF THIS......they wanted me to pay for a stupid diagnostic before they would help me........well screw you I fixed myself. LATER
SOURCE: 2003 Chevy Avalanche rear doors won't lock automatically
The rear doors will not lock with the keyless remote, the drivers master switch
SOURCE: power locks and power mirrors dont work from the
I am currently having the same problem with my 2004 Blazer, after a little research I am going to try replacing the engine compartment fuse *** suggested. I will let you know if tis works.
SOURCE: Power door locks and driver side power window not
You can do it yourself.
Couple of times when you replace the remote battery, you might have them not working/ responding but just follow the procedure below.
Stand close to the car, hold down the open and close knobs for about 10 seconds. Press them at the same time for 3 seconds; then press the open button as the car opens.
The above procedure is applicable to a lot of car brands. It does not matter how many knobs you might have on the remote fob.
I have carried this procedure out on a lot of brands ranging from Honda, Toyota, Rover, Ford, etc. and it works perfectly well.
Good luck and Rate this.
Cheers
http://repairhelpcenter.blogspot.in/2012/02/front-door-dis-assembly-diagram-for.html
------
Rear Door dis-assembly diagram for Toyota car?
http://repairhelpcenter.blogspot.in/2012/02/rear-door-dis-assembly-diagram-for.html
-------
How to test Power door locks?
http://repairhelpcenter.blogspot.in/2012/02/how-to-test-power-door-locks.html
----------
right side slide door light switch on Toyota
Sienna?
http://repairhelpcenter.blogspot.com/2012/01/details-for-replacing-right-side-slide.html
------------
Door locks not working?
http://technoanswers.blogspot.com/2012/01/door-locks-not-working-on-ford-explorer.html
--------------
Power door locks not working?
http://schematicsdiagram.blogspot.com/2011/12/power-door-locks-not-working.html
--------
Repairing car Door lock Actuator?
http://howtobyme.blogspot.com/2011/11/repairing-car-door-lock-actuator.html
How to Access car door panel?
http://howtobyme.blogspot.com/2011/11/how-to-access-car-door-panel.html
Vehicle door panel components?
http://howtobyme.blogspot.com/2011/11/vehicle-door-panel-components.html
----------
This will help.
Thanks.
589 views
Usually answered in minutes!
×