How to replace the fuse in the radio

You need the radio security theft deterrent code, it was given to the original owner with the vehicle info packet, see the dealer for further help.

Start by replacing the 15A radio fuse. That should solve the problem.

check the negative wire from the battery to the body (not good ground ) clean

If it happened after jumping car than Yes look in the main fuse box under the hood and check all fuses there, you may need a volt ohm meter to check some of them...

You radio is in theft lock, contact your local dealer to correct the fault.

It has spark and fuel when the fuse is blown too?

Hi i had sa me issue jump started my kia rio radio display was blank. To fix open your fusebox inside the car Pull out both audio fuses your fuse puller should be in the fuse box under the hood. Yes you have two fuse boxes. One inside you car and one under the hood with your engine. wait few minutes say five... Put the fuse back in. Btw its not neccesary to pull the fuse all the way out. Your radio should show cde error... Now you will need to put in your four digit pin...gluck thanks to the guy on the internet who said pull out the memory fuse... Not that i understood till now.

I would have the alternator checked. Sounds as if you are draining your battery completely down and the alternator is not keeping up.

Your radio/nav system needs a code. Go the your dealer's parts department , give them the VIN of your car( should be free $0). Punch in the code through the car radio and your radio/nav system should work right away.

Yes, replacing the #9 fuse in the fuse box under the glove box seemed to do the trick (Front Accessory Socket). Thank you!!

2008 Pilot...radio was dead...radio fuse was fine.