Where does the ground cable go on a 85 jeep cherokee

SOURCE: I need to replace the battery cables on a 2000

You can just ask at a spares shop for the wires for you specific vehicle, as for fitting them, the negative terminal wire simply attaches to the chassis by a large bolt, and the positive wire usually has a plug on one end, and you can just plug the old one out and insert the new one, make sure to ask the retailer for the plug aswell when you purchase the cables. Hope that helps!

SOURCE: wont turn over but radio comes on

checkout the starter and make sure its good and to see how its engage in the flywheel it maybe stuck or the starter need to be replace.and check all of the wires going to the starter too.

SOURCE: 2004 Jeep Grand Cherokee. Keeps stalling, engine

P0505 means the whole Idle Control system, not only the IAM. Check all related sensors (i.e. crankshaft sensor). Check with a voltmeter direct at the connector of the IAM if you get any signal. Remove the IAM from the TB, connect him, let someone switch your ignition key to ON. The IAM need to drive in/out for a short time to find the right position. Hold the IAM near a hard part, that they cant drive out completely! If IAM works fine, check the fuel pressure, check and clean your TB ( if not done yet). If that doesn't work, come back again please

SOURCE: 1994 Jeep Grand Cherokee; good battery, cables,

Look for main fuse OR fusable link inline (in the main wire) to fuse box

SOURCE: 1994 jeep grand cherokee dash lights come on when

What dash lights come on? if its the brake or ABS lights that means your brake pads need to be changed, in some brake pads there is a sensor that also has to be replaced if you have gone too far into the rotor.