Changed the brake pads and sensors but the warning message inside the car still says the brakes need to be changed. We can't figure out how to reset the dates for that sensor on the computer. We tried a method of putting the key in the last position before starting the car, then pushed the odometer button but that did not bring up the reset menu. Also, disconnecting the battery does not clear the message.
SOURCE: BRAKE WARNING LIGHT
I dunno if this will work on your BMW, but on my BMW Z3 and M3, it was....
Turn the ignition key to position 2, but do NOT start the car. Wait for
about 45 seconds and the brake warning message will be reset.
If it doesn't reset, then the brake sensor was damage. You will need to replace the brake sensor. It sounds like you replace the brake right after you saw the warning, so the brake sensor should be okay.
SOURCE: Mini Cooper 2004 Brake Pad Warning Light Reset
One method describes just turning the key to position 2 and giving it about 30 seconds and that it will reset on its own. A manual method is described here:
Mini Cooper Reset Service Indicators
SOURCE: Brake Pad Sensor
i have replaced both front/ rear pads, and no matter what the dash light will not go off. I have disconnected both front/rear sensors, and light is still on , any suggestions?
SOURCE: Resetting brake warning light
Hi , if you turn the ignition on so that all the dash lights are on , do not start the engine and leave on for aprox 45 seconds the brake pad warning lights should go out, regards mark
SOURCE: how do I RESET BRAKE LIGHT ON 2006 BMW 325I.Brake
that has to be done by a dealership with a BMW specifiic scan tool
58 views
Usually answered in minutes!
×