SOURCE: 98 Jeep Cherokee Fog lights
It's definitely the switch...I bought two of 'em so far...known bug. I don't use the fog lights as much anymore , but the "Airtex" oem equivalent switch from Rockauto seems to be holding up well. If you dissamble your broke switch you'll probably see evidence that it is beginning to melt and theres alot, maybe too much, grease, which may or may not have been the cause of the bad, heating contacts inside switch.
If I remember right, even though the foglights have a relay there is still full amperage going through the switch or something....don't qoute me on that last statement.
SOURCE: 1998 jeep grand cherokee limited fog lights don't work.
This means you have a short. I am assuming you are talking about the fog light fuse. Does this fuse blow whether the fog lights are off? or just when turned on?
If the fuse blows when the switch is off the switch is bad too. If the fuses only blows when the switch is turned on you have a short in the wiring or bulb.
I don't know if you have test equipment so first I would say to remove both driving bulbs from their sockets and see if there is corrosion. Fix that problem if there is corrosion.
Then install a fuse without the bulbs and see if the fuse blows. If you have a test light you can bridge the fuse panel without putting a fuse in. If there is a connection you have a hot wire grounding. If there is no problem install one light, fuse or bridge the fuse holder and see if 1 light works. Try each side. This way you can isolate the problem. Then visibly inspect wiring.
SOURCE: need a fuse box diagram to wire in fog lights
Fog lamps are installed on the front bumper. The switch is located
to the left of the steering column on the dash panel. The fog lamps are
turned off by the circuit relay when the high beam driving lamps are
turned on. The circuit relay is located on the right front wheelhouse
panel near the blower motor.
Good luck, and remember rated this help.
Removal & InstallationFog Lamp Element
See Figure 1
Fig. 1: Exploded view of a fog lamp assembly
DO NOT handle elements with your bare hands, always handle with a
clean cloth. Oil from your hands will cause the element to fail.
Fog Lamp Switch
The fog lamp switch is removed and
installed by simply prying the switch from the instrument panel and
unplugging the electrical connector.
FOGLAMP BEAM ADJUSTMENT
1995 Cherokee Chassis Schematic
www.autozone.com
SOURCE: fog lights don't work
In my 99 Cherokee it was the switch itself. Bought one online for about 20 bucks and it took about 5 minutes to replace.
SOURCE: fog lights will not work on 2001 jeep wrangler
check your grounds on your fog lights make sure they have a good ground.GOOD LUCK.
923 views
Usually answered in minutes!
×