How many quarts of oil is needed in a 2010 750li

Depends on your engine.

1980 JEEP CJ-7 2.5L 4-cyl Engine Code [B]
CAPACITIES
Engine, GM without filter..........2.4 quarts[1]
Wix Filter ........ 51040
Cooling System, Initial Fill..........8.0 quarts
Automatic Transmission, A904, 30RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, A999, 32RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, Total Fill
3 speed A999, 32RH..........8.4 quarts
3 speed A904, 30RH..........7.0 quarts
Manual Transmission, 4-SPD, SR-4..........3.0 pints
Manual Transmission, 4-SPD, T176..........3.6 pints
Differential, Front..........2.5 pints[3]
Differential, Rear..........4.9 pints
Transfer Case,..........4.0 pints

1. Add extra oil when replacing filter. After refill check oil level.
2. With engine automatic transmission operating temperature, shift through all gears.
Check fluid level in NEUTRAL and add fluid as needed.
3. 1984-1992 Models with command-Track, add 5 oz of 75W-90 GL-5 to shift motor housing opening.

TORQUES
Oil Drain Plug.....25 ft-lbs
Manual Transmission T176
Fill Plug.....15 ft-lbs
Drain Plug.....15 ft-lbs
Manual Transmission SR4
Fill Plug.....20 ft-lbs

1980 JEEP CJ-7 4.2L 6-cyl Engine Code [C]
CAPACITIES
Engine, without filter..........5.0 quarts[1]
Wix Filter..... 51522
Cooling System, Initial Fill..........11.0 quarts
Automatic Transmission, A904, 30RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, A999, 32RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, Total Fill
3 speed A999, 32RH..........8.4 quarts
3 speed A904, 30RH..........7.0 quarts
Manual Transmission, 4-SPD, SR-4..........3.0 pints
Manual Transmission, 4-SPD, T176..........3.6 pints
Differential, Front..........2.5 pints[3]
Differential, Rear..........4.9 pints
Transfer Case,..........4.0 pints

1. Add extra oil when replacing filter. After refill check oil level.
2. With engine automatic transmission operating temperature, shift through all gears.
Check fluid level in NEUTRAL and add fluid as needed.
3. 1984-1992 Models with command-Track, add 5 oz of 75W-90 GL-5 to shift motor housing opening.

TORQUES
Oil Drain Plug.....30 ft-lbs
Manual Transmission T176
Fill Plug.....15 ft-lbs
Drain Plug.....15 ft-lbs
Manual Transmission SR4
Fill Plug.....20 ft-lbs

1980 JEEP CJ-7 5.0L 8-cyl Engine Code [H]
CAPACITIES
Engine, without filter..........4.0 quarts[1]
Wix Filter..... 51258
Cooling System, Initial Fill..........13.0 quarts
Automatic Transmission, A999, 32RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, A904, 30RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, Total Fill
3 speed A904, 30RH..........7.0 quarts
3 speed A999, 32RH..........8.4 quarts
Manual Transmission, 4-SPD, SR-4..........3.0 pints
Manual Transmission, 4-SPD, T176..........3.6 pints
Differential, Front..........2.5 pints[3]
Differential, Rear..........4.9 pints
Transfer Case,..........4.0 pints

1. Add extra oil when replacing filter. After refill check oil level.
2. With engine automatic transmission operating temperature, shift through all gears.
Check fluid level in NEUTRAL and add fluid as needed.
3. 1984-1992 Models with command-Track, add 5 oz of 75W-90 GL-5 to shift motor housing opening.

TORQUES
Manual Transmission T176
Fill Plug.....15 ft-lbs
Drain Plug.....15 ft-lbs
Manual Transmission SR4
Fill Plug.....20 ft-lbs

Oilman

call your local auto parts store and ask them to look it up it usually takes between 4-5 quarts. the manuals say 4 quarts but they didn't leave the extra 1/2 to 1 full quart for the oil filter put in 4 quarts start the engine let run for at least 30 seconds then shut off and wait a minute for the oil to settle then check the oil. add how ever much you need to bring the oil level up to where it needs to be

the oil capacity would be as follows :
2007 gmc sierra 1500 series with :
4.3 L with oil filter = 4.5 quarts
4.8 L with oil filter = 6.0 quarts
5.3 L with oil filter = 6.0 quarts
6.0 L with oil filter = 6.0 quarts
6.6 L with oil filter = 10.0 quarts

My 1993 voyager is like that. It may burn some , it definitely leaks some , and it could be just sending some through the PCV valve. Oil leaks and burning oil causes pollution . If you can fix it with a new seal or a valve cover gasket it is easier than constantly checking your oil. Temperature, trailering, speed, outdoor temperature, and engine RPM all can be factors if you are losing oil. If your engine is a quart down, the engine oil consumption rate doubles or triples. In other words the lower the oil level the faster it disappears. High mile cars will drive for years as long as you add oil when it is needed (keep the oil level between the marks). Fix any obvious leaks. Then determine your oil change interval (3000 miles, 4000 miles, 5000 miles). I change between 4000 and 5000 miles. If i am a quart low at 3500 I add a quart. If I am a quart low at 4500 miles I just change the oil in the car. A good practice is to carry a quart of oil in your vehicle just in case you need it. It is far cheaper to add a quart when needed than to go to the dealer once to maybe fix a problem that they may not be able to find or fix. Older engines (even some newer ones) just use oil , especially in hotter climates. Fix the obvious and carry a quart.

A typical automobile holds 4-5 quarts of oil.....Depends on the size of motor. If changing yourself, Drain out all oil, change filter, put oil plug back in. Put 3- 31/2 quarts back into car. put oil cap on and start car. Let run for 2-3 minutes then shut back off. Wait for a few. Pull out dipstick wipe, put back in then pull out a second time...Now you know how much you need to top off level.

750LI E60 4.8 ENGINE USES 6.9 QUARTS OF OIL WITH NEW OIL FILTER.YOU SUPPOSE TO USE 5W - 30 GREEN LABEL SYNTHETIC MOBILE SCH630.

4.8 quarts

i buy the 5 quart jug i drain it all fill it with about 4 quarts start it let it run for about 30 seconds then shut off wait 5 minutes check oil fill as needed. then remember how many quarts it took. there 4.0 v6 is usualy 5 quarts. but do as stated to be for sure. then you have the empty jug to put used oil in for recycle.

2.0L - 3.7 quarts.
2.5L - 4.2 quarts.

With oil filter you'll need 5 quarts. After changing oil and filter run briefly and check for leaks. Shut down the engine and check oil level is correct.
I hope this may have helped,
Tom