I have a 2007 chevy equinox that won't start. Took the battery and starter in and they both tested fine, the battery was a little weak but put it on the charger overnight. when i try to start it i get

SOURCE: my 97 chevy cavalier want start with key

sounds like a bad alternator try this list too 1 Inspect Battery Damaged or faulty battery and/or connections. 2 Inspect Coil - Ignition Damaged or faulty ignition coil or ignition coil circuit. 3 Inspect Fuel Filter Clogged or dirty fuel filter 4 Inspect Fuel Injector Pressure Regulator Faulty fuel injector pressure regulator or circuit. 5 Inspect Fuel Pump Improperly functioning fuel pump or circuits. 6 Inspect Wireset Damaged, worn, or deteriorating spark plug or coil wire(s). 7 Inspect Control Module-Ignition Faulty ignition control module or circuit. 8 Inspect Solenoid Switch Damaged or faulty solenoid switch or solenoid switch circuit. 9 Inspect Starter Damaged, worn, defective, or faulty starter or starter related circuit. 10 Inspect Neutral Safety Switch Damaged or faulty neutral safety swittch or circuit. 11 Inspect Fuse Corroded, burned, or shorted fuse may be interupting power source. 12 Inspect Fusible Link Corroded, burned, or shorted fusible link may be interupting power source. 13 Inspect Battery Cable Corroded, broken or poorly connected battery cable. 14 Inspect Spark Plug Wire Loom - Performance Improperly adjusted or worn/malfunctioning carburetor. 15 Inspect Distributor Cap Loose or cracked distributor cap 16 Inspect Distributor Cap And Rotor Kit Loose, cracked, or worn distributor cap and ignition rotor. 17 Inspect Fuel System Pressure Incorrect fuel pressure being delivered to carburetor or fuel injection system. 18 Inspect Fuel Injector Plugged, dirty or poorly connected fuel injector. 19 Inspect Ignition Switch Worn, damaged or faulty ignition switch or circuit. 20 Inspect Spark Plug Fouled, damaged or broken spark plug(s). 21 Inspect Belt Incorrectly routed, adjusted(tensioned), missing or worn drive belt(s). 22 Inspect Timing Belt Slipped or broken timing belt. 23 Inspect Timing Set Slipped timing chain or worn timing gear(s). 24 Inspect Fuel Tank Contaminated fuel from rusted or deteriorated fuel tank. 25 Inspect Ignition Timing Incorrectly adjusted engine timing.

SOURCE: no power to starter 2004 chevy tahoe

Hi
It could be your neutral safety switch. It could be the starter relay which is located in the fuse panel box. It could be the smaller wire going to the starter could be loose or corroded.

SOURCE: my 2004 chevy malibu will

Is the motor locked up??? If the starter is engaging the flywheel (Loud "click" when key is turned) and the engine is not cranking, the engine may be locked up. Try to turn the engine by hand ny placing a socket on the crankshaft pulley bolt and using a ratchet to try to turn the pully in a clockwise direction. If it does not turn, try taking all the spark plugs out and try it again. If it turns with the spark plugs out, look for antifreeze coming out of the spark plug holes when you turn it....if anyifreeze comes out, your problem is caused by a a blown head gasket. Also pull the oil dipstick out of the tube and look at the condition of the oil. If it looks like a chocolate milkshake, your engine has probably locked up due to antifreeze getting into the oil from a blown intake manifold gasket.

Clifford Beard

• 1975 Answers
• Posted on Apr 03, 2011

SOURCE: I have a 95 chevy

There is a fuse from the ignition switch. There is also a fusible link. Below is a wiring diagram that you can look at and it has the wire colors as well. This I hope will help you narrow down your power loss to the solenoid. If you need anymore wiring diagrams for your vehicle I have them all and you are free to email me at [email protected] with what you need. No cost, Being nice cause it's Sunday....LOL Anyway, I hope this helps you and good luck. Here's your diagram

SOURCE: 2007 chevy cobalt ls won't

Ignition relay or fuse could be the problem. When you turn the key to start do you hear a fuel pump kicking on and or do you have spark when you hot wire the starter (I know it's hard to check while trying to start it)? You can email me back and I might be able to pinpoint it more.