Installing timingbelt mazda 2500 tubodiesel-wlt-3

https://www.mahle-aftermarket.com/media/local-media-north-america/pdfs-&-thumbnails/torque3.pdf

This manual should have the specs you are looking for.

Valve Clearance - Ford Mazda - 4x4 Community Forum

www.4x4community.co.za > ... > Ford & MazdaAug 13, 2010 - 8 posts - ‎4 authors Valve Clearance - Ford Mazda Ford & Mazda. ... Mazda BT-50 4x4 2.5

You get instruction book with the new belt

You look at your factory service manual before you
start any job

You could try the internet or you tube video

no code = water in fuel ?pos.=change fuel filter

for the most part its under the dash on the passenager side or under the hood on the passenager side

usually around 60,000 miles or 48 months, which ever comes first.

have u a spark, if so check the timings not 180degress out

Removal & Installation

1. Disconnect the negative battery cable.
2. Remove the intake manifold.
3. Disconnect the sensor connector.
4. Remove the sensor from the engine block.
5. Installation is the reverse of the removal procedure.
   
   Fig. Knock sensor removal and installation-Mazda 3
   

1. Disconnect the negative battery cable.
2. Remove the intake manifold bracket.
3. Disconnect the sensor connector.
4. Remove the sensor from the engine block using special tool 49H018001 or equivalent.
5. Installation is the reverse of the removal procedure.
   
   GL G

http://jdmultimate.com/Store/Product/ItmItem.aspx?ItemId=176995&Make=MAZDA&Model=B2500
There you go if you need anything else let me know. I hope you find this appropriate for a FixYa rating.
Thanks,
Lee