2008 Jeep Grand Cherokee Logo
T
Tomray Posted on Dec 12, 2013

Lift gate open warning light sounds when temp is below 60

When the temp is below 60, the lift gate open light, bell and lights come on. they dont stay on, but go off and on often. the bell will literally go ding, ding ding repeatedly. jeep doesnt know how to fix it and neither do 2 other mechanics. i have spent almost $500 on this and its driving me nuts! help!

1 Answer

jaglor

Level 1:

An expert who has achieved level 1.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 53 Answers
  • Posted on Dec 06, 2014
jaglor
Contributor
Level 1:

An expert who has achieved level 1.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: May 13, 2009
Answers
53
Questions
1
Helped
23326
Points
89

Sounds like the cold temps cause the metal door to warp which causes an increased distance to the sensor that tells the computer the lift gate is open. The lift gate sensors should be adjusted to be closer together.

5 Related Answers

Denis Aube

  • 142 Answers
  • Posted on Jan 13, 2009

SOURCE: airbag light stays on 2005 jeep liberty

It probably will cost a few bucks to get the code reset, but you don't need to go to the dealership, most shops with a good scanner equipped for air bag code reading will be able to diagnose and reset the light. The most probable reason for the code is the battery being dead for a while, there is a capacitor in the airbag circuit to make sure the airbag can go off in a collision even if the battery disconnects itself in the process. There is a slim chance it might be something else but either way the shop should be able to tell you what the problem is, and get it fixed... But, just for fun, before doing all this, i'd disconnect the battery for 30 minutes to an hour and reconnect it back, some systems do effectively reset themselves this way.

Ad

Anonymous

  • 1 Answer
  • Posted on Jan 14, 2009

SOURCE: 1999 Jeep Cherokee

I've had the ABS problem several times, and each time it was a failing wheel speed sensor.

Anonymous

  • 3533 Answers
  • Posted on Mar 12, 2009

SOURCE: Intermittent overheating on 96 Jeep Grand Cherokee

I had this same problem on a taurus and did all the things you did and found out after that the coolant reserviour bottle had a crack in the bottom of it

Anonymous

  • 6784 Answers
  • Posted on Apr 23, 2009

SOURCE: lift gate wont open

OK, this minor collision may have shifted the actual clip and latch assembly. You may have to totally disassemble the latch assembly to release this lift gate.

Any kind of major or minor shifting of the lift gate lock latch assembly can cause misalignment that will jam this delicate precise locking mechanism.

ZJLimited

ZJ Limited

  • 17989 Answers
  • Posted on Aug 05, 2009

SOURCE: Lift Gate will not open

Compared with this reference documents: ZJ-Secc-8P-Power-Door-Locks

Good luck... and rated my help!!!

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2008 Jeep says lift gate open but it's not. Interior lights stay on

This sounds like a signal/switch issue. Check the tail lift switch. It may be a button built into either the tailgate or the frame it sits in. It'll will probably be a spring loaded button that is pushed in when the lift gate is closed.
Also check the wire harness that feeds from the body to the lift gate. These flex every time you open and close the lift gate so the wires inside can wear out or snap over time.
0helpful
1answer

Lift gate issues

You need to replace the rear latch assembly it sounds like the switch inside latch is going bad.
0helpful
1answer

Should the interior light come on when I open my lift gate on my 2007 Tahoe?

Yes. The gate is like any other door for the light system.
0helpful
2answers

Lift gate open

Has anyone suggested replacing the BCM (body control module)
0helpful
1answer

Dome lights

Do you get a door open warning if either of these doors are open?

If you need further help, reach me via phone at https://www.6ya.com/expert/tom_1788908372a4836f

0helpful
1answer

Radio, dome light and door open warning bell doesn't work

try changing fuses any way somtimes there dirty or coroted and dont make good contact even though they test good and look good still could be the problem
1helpful
1answer

My lift gate says that its open when its closed and my interior lights will not turn off

there is a push button switch in the door jamb for the lift gate. look closely and you will find it. when the door is shut the button is pushed and the interior lights and open door warning go off. it is broken and you need a new one. this will be a dealer item and it snaps or screws in. when you get the new switch you may want to pay someone with mechanical aptitude to replace it.
0helpful
1answer

It seems that I have a short in my wires. My tail lights wont stay on. My problem is the lift gate is stuck and I cannot access the lights. When u use the remote to open the doors it makes a funny sound....

You should be able to remove the trimpanel on the lift-gate. then at the location of the striker in the middle-bottom of lift-gate you should be able to access a rod. Grab the rod with pliers, if pliers won,t fit the rod connects to a metal lever attached to the striker assembly, pry the lever away from the striker and this should release you gate....Good Luck!!!
2helpful
1answer

Warning bell won't stop sounding

Section 13-09: Gauges, Warning Devices — Chime System 1996 Windstar Workshop Manual
DESCRIPTION AND OPERATION Warning Chime Systems Three distinct sounds are used to indicate the area of concern. Seat belt warning generates 1 chime per second
key-in-ignition generates 2 chimes per second
headlight on generates 4 chimes per second.
Key-In-Ignition Warning The key-in-ignition warning will sound when the driver's front door (20125) is opened with the key in the ignition switch. It will continue to sound until the key is removed, the front door is closed, the ignition switch is turned to START or the vehicle speed is over 24 kmh (15 mph).

Safety Belt Warning When the ignition switch is turned to RUN or START from OFF or ACC, the chime will sound for six seconds or until the safety belt is buckled.
  • The safety belt warning indicator lamp (10C859) will activate for 60 seconds or until the driver's safety belt is fastened. Both the chime and lamp activate at the same time.
Anytime the ignition switch is released from START and returns to RUN while the safety belt lamp or chime is activated, the safety belt warning lamp or chime will remain activated until either the timing sequence has been executed, or the safety belt is buckled.

Headlamp Switch On Warning The chime will be activated if the headlamps or parking lamps are ON, the key is not in the ignition and the driver's door is opened. The chime will sound at a rate of four per second.

Not finding what you are looking for?

284 views

Ask a Question

Usually answered in minutes!

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...