My car has lost all power to all devices

SOURCE: drivers door power lock wont work.

Either the wring going to that motor or the motor itself is bad.

SOURCE: Remote works but doors don't lock/unlock

Check the remote battery or replace. Check all fuses. If you need to reprogram, try this.

key not in ignition.
driver door open-others closed
driver door unlocked

1-insert and remove key from ignition two times

2-close and open driver door two times

3-insert and remove key once from ign.

4-close and open drvr door twice

5-insert key into ign.,then close driver door

6-turn key to on (not start) then off, twice
this is rewrite mode,have all remotes to reprogram
it will clear any lost remotes.

7-remove key from ignition,the door locks should cycle twice.if not start over.it may take a few tries.

8-press lock/unlock together and hold for a second

9-release,and press lock on remote,the door locks will cycle confirming program.continue to do other remotes you have,steps 8 and 9.if only one in possesion,you are done.

to end mode open door or insert key into ig.you can do up to 4 remotes.read this a couple of times to get the sequence down.there are time restraints,but if you go in order it will work.do not wait more than a second b/t each step and you will be ok.i know from experience that you can do this as fast as you can and it will enter mode.if steps out of order or you wait to long it wont.print this and have in lap,read ahead of what you are doing.good luck

SOURCE: 97 Toyota Camry aut. door lock and dash clock not working properl

i HAD the same problem.... first check the fuse under the hood labeled 'dome' should be a 7.5A it is blown for sure... also if you are good with wiring and at working on cars look at the drivers side doo wiring (between the inside door jam and the drivers side floor... its the wiring that goes through the door to the cabin.... anyway you have to take off the door panel and remove a small cover on the floor of the drivers side.... now remove the two connectors that go to the wiring harness.... you should now be able to loosen the grommet and pull the wiring harness through the door via the speaker hole (you should have removed the speaker already) you now must inspect the wiring which is most likely frayed and/or broken now fix the wiring with some new wiring and crimp connectors and heat shrink your work.... should be good as new... have fun getting the wiring back through the door... it will be bigger due to the crimp on connectors etc..... i did a quick write up of this so i hope it is understandable