How do you change the time on the clock? - 1997 Chrysler Town & Country

Could you post a photo of the clock and the area of the dash it is in? There is usually two different methods of changing the time on the clock.
The older method is to use buttons or a roller switch that are on or near the clock display. The newer clocks are usually setup on the touchscreen by going to the 'settings' area.
Try this website to see if it helps.

https://www.empirehyundai.com/blog/2019/january/29/how-to-change-your-car-clock-for-daylight-savings.htm

No . You can live it or replace it. Look on E Bay.

Try the owners manual?

I don't know what your dash layout is but you must be able to set the clock time.

If the clock display is in the hooded centre dash panel press set for more than one second to enter clock/date menu then press set briefly to move through the settings. Try pressing H and M at the same time to change from 12 to 24 clock.

What question

Make sure the clock is set to the correct time zone before trying to set the time.

Dear Sir!
Beside the digital clock must be 2 switches, one is for hours and the other is for minute, if it is not when the time is 12:00 take out the clock fuse and enter it again the time will be automatic 12:00.
The clock fuse is under stearing wheel.
Hope to hepled you.
Mustafa, Kabul Afghanistan

Try this, put the key in the ignition and let it be on the first turn right marked "ACC" or you can turn off the stereo and you will notice that only the Digital Clock screen will show. Turn the Volume/Audio/Sel knob and press on the "DISP" button simultaneously for about 4 seconds then release the "DISP" button. The digital clock will start blinking, and then use the Tune/Seek arrows pointing up and down to change the time. If the hour digit is blinking change the hour and after you have changed it press "DISP" then the minute digit will start to blink change it using the arrows, when you are done press "DISP" again or leave the clock for between 4 to 8 seconds the clock will start working normally.

I hope this works for you.

Good luck!

Aquinas

press the menu button for a few seconds...then it will say adjust clock...then just use the arrows to change clock...simple..even i can do it...

kavtrom to reset the clock you use the instrument cluster by navigating the steering wheel multi function keys untill cluster states settings-after you have set the time while the instrument cluster multi function screen is still at the clock settings you have to press the the reset button/dimmer knob on left side of instrument cluster and the clock will go backwards until 9-10 oclock and then will forward itself to the correct time

FROM THE OWNERS MANUAL:

Setting the clock: Press RDS until SELECT HOUR or SELECT MINS
is displayed. Press SEL to increase ( ) or decrease ( ). Press
RDS again to disengage the clock mode.