2008 pathfinder abs slip 4x4 lights are on - 2008 Nissan Pathfinder

What do you mean for ABS or speed?

brake sensor prob try drying with hair dryer

These systems are tied together, you may have one of the following problems. Could be a bad ABS senor, one of the modules my be bad, a wiring issue or a problem with the PCM (powertrain contol module). Have it checked by a techician that knows your make of vehicle.

This means there is a problem with you ABS system. You will have normal brakes. You should be aware that this may cause an ABS activation at low speeds, which my cause the brake pedal to drop. It could be a sensor, wire or module thats needs repair or replacement. Get it checked by a technician that knows your make and can do the proper checks. It will save you own time and money.

Accelerator Pedal Position Sensor needs replaced

Your computer was not upgraded when the recall was done, take to dealer and tell them to upgrade your computer to reflect the changes made during the recall.

If this issue is since a recent repair, then check wiring for signs of damage or disturbance under the car before proceeding.

Sounds like a failed/damaged wheel speed sensor problem to me.

to get rid of 4x4.while running, put your truck in N, foot on brake and change the selector out of 4 LOW. you should get indication on your dash, no 4X4 flashimg and back into 2WD. If the VDC light is on, its linked to your ABS so check your brake fluid levels. Good Luck

was toll before disconnect the battery for five seconds and it will clear all the lights codes