It sound like you have a bad ground, what will happen if this is the case is you put you key in the ignition and turn to run "not starting the engine" and everything is on and bright, when you try to turn the engine over it will click once "just when the key hits the start position" and everything will shut off lights and all. if you take the key out and do it again it will produce the same results.
I’m happy to assist further over the phone at https://www.6ya.com/expert/brock_d67526d2a834c47e
SOURCE: No power after new battery on 2005 Tundra
was the battery fully charged before installing it ? if it ran good before you installed the battery then it has to be your new battery at fault ?? unless i missed something here .. did you clean all posts inside the battery cables ? holler if you need more
SOURCE: Car wont start, no power....not battery related
there will be some fusable links at the + of the battery they look like plane wire but have very soft insulation you will need a tester light or multimeter to chec if the power is going through them and have a look at the inside of the battery terms for yukky corosion one more thing check the cable giong to the body from the - term that it is connecting properly tp the body surface
SOURCE: 2005 Caddy V8 sts no longer remote cranks. lights
I had the same problem with my STS. Go back through your programing menu and "check" remote start again. Somehow, mine defaulted to not allowing remote start feature. It was good to go as soon as I re-programmed it.
217 views
Usually answered in minutes!
×