I start driving it dings for 10 seconds then i stop and start driving and it dings again ect.
SOURCE: Emergency break pedal stuck to floor, but break is disengaged
sounds like your brake cable has broken or there is something damaged in the pedal assembly.........try pulling on the release handle and move the e-brake pedal back to its off position by hand at the same time.(you may have to tie it in this position to keep it up)If that doesnt work there is a sensor on the pedal assembly that you should be able to bypass by either disconecting the wire(1 wire system) or connecting the two wires together (2 wire system)Especially if your truck is a standard the e-brake is an important safety feature,so if these steps fix the light and dinging problem you should still take the steps to have it repaired.
hope this helps.........Good Luck!
SOURCE: A B S brake light on
Disconnect negative terminal on the Battery, with Key on ignition ON engine not running and radio ON, after two minutes or more connect it back, do not panic if sparks come wile connecting it back, make sure is clean and ***, go to Your ignition key and turn it of, then start the car and see if problem remains, you have a bad sensor or a an ABS problem
SOURCE: 2007 uplander keeps dinging
It is a bad oil sensor. Tells your car oil pressure is low when it isnt it is warning you. They are $30 at o reileys and just a plug and a clip. Easy to change !
213 views
Usually answered in minutes!
×