Keyless remote 03 s type Jaguar. Keyless remote wont work even when I changed the battery. Help

SOURCE: keyless reprogram

resychronizing the key works.

1. Insert key into ignition and turn to
position 2.
2. Remove key and hold down lock button
while pushing unlock button five times.
3. Release all buttons, then push either lock or
unlock button.
!!!!!!!!!!!!!Procedure must be completed within10
seconds.!!!!!!!!!!!!!!!!!!!

SOURCE: keyless remote wont work dont know how to program

I have a 2004 Kia Optima EX V6. You have to get a new battery for your key fob(s) and take to dealer to program it. It can only be programmed when they hook it up to the computer. Cost around 40 bucks from Kia. Call around some use to charge only 10 bucks. Good luck.

SOURCE: '03 Hyundai Elantra - Keyless entry remote not working

It wouldn't be the car battery, but since you just purchased the car, the dealership should correct the problem. Bring it to their attention right away. Did you get any kind of warranty? Most dealers have at least a 30 day warranty for things like this.

SOURCE: keyless entry wont work after battery died

stand at the vehicle and push and hold the lock and unlock buttons till the horn chirps to resync the key fob

ZJ Limited

• 17989 Answers
• Posted on May 08, 2010

SOURCE: Keyless remote stopped working, I replaced battery

The 1997 to 2003 Dodge Caravan and Grand Caravan use a standard key and remote setup with a separate remote fob. However, the 2004 to 2009 Dodge Caravan and Grand Caravan use a combination key and remote on one device. To program a new keyless entry remote for the 1997 to 2003 Dodge Caravan, you must have at least one functional remote, which is required to enter synchronization mode. To program the combination key for the 2004 to 2009 Dodge Caravan, you must have two functional combination keys. If you do not, you'll need to see an authorized Dodge dealer for keyless entry programming assistance.


2004 to 2009 Caravan Programming Instructions

1. Insert one of your working combination keys into the ignition. Turn it to "On"; leave it in this position for about 10 seconds but no longer than 15 seconds. Turn it to "Off" and remove it.
   
2. Insert your second working combination key into the ignition within 15 seconds of removing the previous key. Turn it to "On". After 10 seconds, you'll hear a chime and the "Theft" light will begin to flash, entering synchronization mode. Turn the key to "Off" and remove it.
   
3. Insert the combination key you want to program. Turn it to "On." After 10 seconds, you'll hear a chime; then the "Theft" light will turn off. When the light turns off, the combination key--including the key and the remote--is programmed.
   
4. Repeat Step Three for each combination key you want to program. A total of eight can be programmed.