No power but battery fine

There are fuses and relays everywhere. You need an auto electrician.

https://www.google.com/search?q=auto+electrician+near+me

1. main motor relay.

• IGN - ignition;
• STOP - brake lights;
• GAUGE - O / D valve, instrument panel warning lamps, 2WD-4WD switching valve;
• CHARGE - battery charging system (lamps);
• TAIL - side lights;
• ECU + B - (electric control unit battery) - electric control unit powered by battery;
• DOME - interior lighting;
• ECU + IG - (electric control unit ignition) - electric control unit for power supply from the ignition lock;
• DEFOG - rear window heating;
• HEAD (LH) - left head light;
• ENGINE - consumers - distributor, main relay, control units;
• A / C - air conditioner;
• WIPER - windscreen wipers;
• TURN - turn indicator system;
• HEAD (RH) - right head light;
• RADIO - radio;
• CIG - watch, cigarette lighter;
• FOG - fog lights;
• HAZARD - alarm, sound signal.

Fuse box diagram Toyota Town Ace Noah and ...

FuseAndRelay.com https://fuseandrelay.com > toyota > town-ace-noah

The main fuse and relay box in the passenger compartment is located under the dashboard, on the driver's side, behind the protective cover. Type 1. Photo - an ...

‎Location · ‎Type 2 · ‎Passenger compartment fuse...

The keyless entry system consists of the following components:

• driver door module (DDM)
• keyless entry transmitter
• keyless entry keypad

The driver door module (DDM) receives inputs from the digital transmission range (TR) sensor, ignition switch, brake switch, window/door lock switches, lighting control module (LCM), keyless entry keypad switch and remote transmitter. The DDM outputs consists of keyless entry keypad switch illumination, power door lock actuators, luggage compartment release solenoid, horn relay, and lighting control module (LCM).

• Battery junction box (BJB) fuses:
  • circuit breaker 7 (20A)
• Central junction box (CJB)
  • 4 (10A)
  • 6 (15A)
  • 8 (25A)
  • 13 (5A)
• Keyless entry keypad switch
• Power door lock actuator
• Luggage compartment release switch
• Luggage compartment release solenoid
• Connectors or connections
• Wiring harness
• If fuse's good have checked for DTC'S - diagnostic trouble codes .
• B1526 Keyless Entry Circuit Short to Ground DDM Go To Pinpoint Test E . B1553 Decklid Release Circuit Short to Battery DDM Go To Pinpoint Test B . B1751 Park/Neutral Switch Circuit Short to Battery DDM Go To Pinpoint Test K . B2425 Remote Keyless Entry Out of Synchronization DDM Go To Pinpoint Test L Need a professional grade scan tool to check fro these codes . Not a code reader for OBD2 codes .

• The doors do not lock/unlock using the remote transmitter

• Remote transmitter not programmed.
• Remote transmitter.
• DDM.

• Go To Pinpoint Test F .

Did you program the new key fob ?

Remote Transmitter Programming NOTE: All remote transmitters are programmable and must be set at the same time.

1. Turn the key from OFF to RUN four times within three seconds, ending in RUN. The locks will then lock and unlock, confirming program mode has been entered.

1. Press any button on each remote transmitter to be programmed. The doors will lock and unlock to confirm that each remote transmitter has been programmed.

1. If additonal remote transmitters are to be programmed, repeat Step 3 within 7.5 seconds or steps 2 and 3 if more than 7.5 seconds have elapsed.

1. To exit program mode, turn the ignition to START or wait 7.5 seconds.

1. NOTE: Failure to wait at least 20 seconds will cause programming failures. Wait at least 20 seconds after turning the key to OFF or after the last remote transmitter has been programmed to activate a remote transmitter for testing or verification

if you installed an aftermarket stereo, the tail lights run through the illumination. make sure all wires are hooked hot to hot and ground to ground. if you installed it while battery was hooked up and touched a wire, most likely blew a fuse

If I understand correctly, the headlights and brakelights work but the vehicle will not start and the dash lights do not work. That sounds impossible, so I'll merely suggest that you check the battery connectors and see that they are tightened down snug.

You should not be able to easily move them with a pliers. Sometimes, if you loosen them just a tad, and twist them a little, and retighten, you get better contact.

Check for a melted fuse box and wire located on top of the battery.

check the fuses the dash lights and tail light share a fuse the head lights and brake light have there own fuses

Check the alternator, it may not be charging or blown fuses near battery

My brake lights are out, the back, reverse, and head lights all work. My steering is fine as well as my brakes. But the warning lights for brake and ABS light up on my dash board

Check all fuses in dash and under hood. Check for any fuse links that may be burnt.
The lights all work on direct battery power without key on,so it is probably a fuse problem.

Ypou have blown the main fuse is held in with two bolt left side of engine compart mentunder a black cover i think is a 60 or 90 amp fuse. hope this helps.
wayne