SOURCE: how do i replace the fuel pump in my 1993 mazda 626 2.5
1. Relieve the fuel pressure and disconnect the negative battery cable.
2. If not already removed, depress the clips on each end of the rear seat cushion and remove the cushion.
3. If not already done, detach the electrical connector from the fuel pump/sending unit.
4. Remove the attaching screws from the fuel pump/sending unit access cover and remove the cover.
5. Disconnect the fuel supply and return hoses from the fuel pump/sending unit.
6. Remove the attaching screws and the fuel pump/sending unit from the fuel tank.
7. Detach the sending unit electrical connector, remove the sending unit attaching nuts and remove the sending unit from the fuel pump assembly.
To install:
1. Attach the sending unit to the fuel pump assembly and install the nuts. attach the sending unit electrical connector.
2. Install the fuel pump/sending unit into the fuel tank with a new gasket and install the mounting screws.
3. Connect the fuel supply and return lines.
4. Install the access cover and the mounting screws.
5. Attach the sending unit electrical connector.
6. Position the rear seat cushion over the floor, making sure to align the retaining pins with the clips. Push down firmly until the two retaining pins are locked into the rear seat retaining clips.
7. Connect the negative battery cable, start the engine and check for proper system operation and for fuel leaks.
SOURCE: How to Replace a Fuel pump on a 2000 Mazda 626
yes it isn't that much if you buy them.they slide inside the coupler and release the line.
Testimonial: "Thank you didn't know if there was a tool for this."
SOURCE: mazda protege fuel pump 02
to take the seat out you have to pull up on it hard. before u start connect the neg. side of the battery. open the gas cap to help to let the or some of the pressure out of the tank.remove the fuel pump cover and unplug the electrical connector and disconnect the wire on top of the fuel pump. disconnect the fuel supply and return hoses from the pump. be careful when trying to unscrew to screws you might have to tip on them to loosing up the lock tight that was put on the screws from the factory. than carefully lift the pump out. disconnect the electrical and move the hose clamp clear the pump fitting. remove the band securing the pump to the bracket and bracket at the bottom of the pump with the rubber mount. remove pump and always remember that gasoline is extremely flammable so take extra precautions when you work on any part of the fuel system. good luck.
SOURCE: fuel pump replacement 2002 mazda miata
The fuel pump is in the fuel tank. You may be able to access the fuel tank by removing your bottom rear seat cushion. If no access there you must remove the fuel tank. If you have to remove the tank and it is mostly full you should siphon out as much fuel as you can into appropriate containers.
446 views
Usually answered in minutes!
×