WHERE IS MY WIPER MOTOR RELAY LOCATED
SOURCE: replacing belts after replacing water pump on 1996 nissan quest x
the easist way is to loosen the alternator slide the alternator down then slide the belt where it should go then pull up on the alternator again and bolt up Please rate my response thank you very much
SOURCE: how many motors mount have a nissan quest 1996
it has three, one rear, one right rear and one front.
SOURCE: how do I remove front wiper blades to replace with
How to Replace Wiper Blades Guide:
Potential tools needed to replace wiper blades:
To replace wiper blades the actual action of replacing the blade is no big deal, it's the location of the blade down below the hood that can make it difficult though. Sometimes it helps to open the hood to gain access to the wiper blades. Other times it is helpful if the wiper blade is somewhere in the motion line of wiper action. The trick is to get the wiper to stop somewhere in the wiper arc. Turn the wipers to the on position and allow the wipers to start, and then shut the key off when the wiper has arrived in a desirable position on the windshield. To replace your wiper blades please follow the step by step instruction below. Also, watch the How to replace wiper blades video below to gain additional information. The method in which the wiper blades are attached will vary slightly.
Common Problems:
I hope help you with this (remember rated this help) Good luck.
215 views
Usually answered in minutes!
×