Cars & Trucks Logo

Related Topics:

h
hector molina Posted on Dec 01, 2013

Fusible links for the ignition on a 1995 isuzu trooper

3 Related Answers

Anonymous

  • 6966 Answers
  • Posted on Jun 16, 2008

SOURCE: Cylinder number for firing order for 1995 Isuzu Trooper

Hi,

Assuming your 1995 Isuzu Trooper is using the 3.2 SOHC engine, the firing sequence would be as shown here.
351636c.jpg. This was originally posted here. An actual image 47d297f.jpg which was originally posted here.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

Ad

Anonymous

  • 1 Answer
  • Posted on Nov 07, 2008

SOURCE: 1995 Isuzu Trooper--Power Windows wont roll down

Check the circuit breaker in the fuse panel on the driver side kick panel. It is a small brown push button directly above the replaceable fuses. My girlfriend has the same year trooper and this has happened to her in the past. I found the breaker and it took care of the issue.

Anonymous

  • 11896 Answers
  • Posted on Jul 02, 2009

SOURCE: where is the mass air flow sensor located in the

Usually on front of engine or by top of radiator. You can go to autozone.com and register for free. Then you will have access to full free online repair manual and how-to's

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Where is the starter switch located in a 1995 isuzu trooper LS. Not sure if there talking about key switch or other in column.

The key lock cylinder operates the ignition switch sometimes ignition switch is separate sorry I didn't find where ignition switch is located if the lock cylinder is plugged into it.
You should have a starter relay and starter relay fuse.
This diagram of starter circuit shows the clutch pedal switch in the circuit on an automatic should have the neutral safety switch in the circuit. This is for 95 Rodeo.
Stater Motor Circuit Diagram (1995-1997 2.6L Isuzu Rodeo) (easyautodiagnostics.com)

How do I remove the key ignition cylinder? ' Isuzu SUV Forum (planetisuzoo.com)
Isuzu Trooper Ignition Switch Replacement ' Cost & Service ' RepairSmith
Changing the Ignition Lock: Changing the Ignition Lock, Safley ... (2carpros.com)
Starter and solenoid
Isuzu Trooper Starter replace under 1 Hour - YouTube
Isuzu Trooper (1995 - 1996) - fuse box diagram - Auto Genius
Starting System & Wiring Diagram - YouTube



1helpful
1answer

What does this code mean? No tach signal to ECM - No Distributor Reference Pulses{4}

ISUZU INFORMATION AND LINKS - Front Range 4x4 Forums

www.frontrange4x4.com > Forum > Tech Topics > Make & Model Links
Apr 7, 2008 - 8 posts - ‎2 authors 12 No tach signal to ECM - No Distributor Reference Pulses{4} ... solenoid circuit failure - 1987 and 1995 Amigo/Pick-up, 1989 to 1994 V6 models ... {9}-Amigo, Pickup,Rodeo & Trooper w/2.6L engine & 1988-91 Impulse.
0helpful
1answer

My engine was having a slow start. Thought I needed a new battery. Bought one and stalled it. But the entire electical system went completely out! My installer also accidently hooked negetive and positive...

When you connect the battery backwards you can cause major damage. You can blow the alternator or its fusible link. You can destroy electronics, particularly the various computers - and these are not cheap
0helpful
1answer

Troubleshoot code 42 on 1995 isuzu trooper 3.2l engine

Code 42 is "Ignition Spark Timing". Either the engine (Cam/Crank) timing is off, or there is a problem with the ignition wiring, the ignition module or the engine control module.
0helpful
1answer

1995 isuzu trooper 3.2 (3 sets of wires comming from gearbox ?) dose any one no what they are for Thanx Gordon

detent switch has two wire bullet connectors,
another detent switch which is reverse lights that also has bullet connectors.
put blue to blue and red to red if not car will not turn off with ignition key.these are on upper section of gearbox the third is a speedo sensor at rear. one oxygen sensor at front section which could be separate section of engine harness
0helpful
1answer

1995 isuzu trooper caliper removal

remove front wheel ,look at back of caliper and and look for teh two retaining bolts that hold the caliper to the support bracket.if not sure take it to a garage as any mistake could kill someone
4helpful
1answer

Cylinder number for firing order for 1995 Isuzu Trooper

Hi,

Assuming your 1995 Isuzu Trooper is using the 3.2 SOHC engine, the firing sequence would be as shown here.
351636c.jpg. This was originally posted here. An actual image 47d297f.jpg which was originally posted here.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.
Not finding what you are looking for?

54 views

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...