97 dodge avenger driver side abs wires ripped out of fender wall when the lower lateral arm let go so i need the abs diagram so i can fix it

SOURCE: 2008 Dodge Avenger window problem?

Sounds like u have a bad window regulator which is a system of channels and guide wires that move the window up & down. since i do not know the whole situation I would make sure the window channels are lubricated with silicone spray to make sure the window is not being held up on anything.

SOURCE: diagram for a serpentine belt replacement for 2000 avenger dodge

HI. i have posted the diagram requested below.

Testimonial: "This was exactly what we needed, Thank you so very much. "

SOURCE: how to replace lower control arm w/ balljoint on

Jack and stand your car on side to replace the arm, remove wheel,it might be easier to remove the brake rotor and caliper out of the way, now there is a shock tower that the axle goes through, remove the lower bolt, next remove the ball jiont nut and cutter pin, hit the spindle area of ball jiont, carefull to not hit the threads, remove the nut that holds the sway bar link to arm, this one can be very stuburn, remove the bolt that holds the arm to kframe, and pry the arm out, reverse the procedure.highly recommend penatrating fluid to all nuts and bolts days prior to teardown to sink in the areas. GOD LUCK, RDJRP

SOURCE: I need a diagram for

the belt routing should be under the hood or on the upper rad support.some of these are on the timing cover in the form of a placard.if it is missing then draw the routing of the belt before you remove it making sure you draw all the pullys and how the belt goes around them.or you can get the routing from the parts store you bought the belt from.or the library has books that will show it for your car and motor

SOURCE: need a 3.5 engine mounting

Give a picture of a u.joint