SOURCE: crank position sensor location
you will need to remove the starter to gain acess to the ckp sensor. once you remove the starter look on the engine block and you will see the sensor. The only problem with doing this repair yourself is that you will not be able to preform the crankshaft position variation learn procedure with out a factory scan tool. The vehicle may crank an run, but the timing advance curves will be wrong so the vehicle will probably cut off every time you remove your foot from the gas pedal. Hope this info helps!
I’m happy to assist further over the phone at https://www.6ya.com/expert/jonathan_3a3c556b4b17d1d2
SOURCE: 1997 Dodge caravan crank position sensor
it is located on the bellhousing of the transmission it gets its signal from the flywheel.look where the transmission bolts to the engine.
SOURCE: location of crank position sensor on 92 chevy corsica 3.1
You will have a no start or stalls after engine gets hot and then cools down restarts, the sensor is on the front of the engine mounted into the cam gear cover if it is not visiable get under the, (here is a picture) car and look.
SOURCE: I CANT LOCATE CRANK POSITION SENSOR
7X Crankshaft Position (CKP) Sensor
Lower rear of engine
4
25
--
24X Crankshaft Position (CKP) Sensor
Right hand side of engine, at end of crankshaft, behind harmonic balancer
7X Crankshaft Position (CKP) Sensor
Lower rear of engine
4
25
--
24X Crankshaft Position (CKP) Sensor
Right hand side of engine, at end of crankshaft, behind harmonic balancer
Right hand side of engine, at end of crankshaft, behind harmonic balancer
31 views
Usually answered in minutes!
×