2008 dodge nitro 3.7 firing order - Nitro Dodge Cars & Trucks

SOURCE: 2008 dodge nitro 3.7 engine. The engine missfires

Have it checked for trouble codes sounds like it could be an injector problem or something as serious as a loose rocker,maybe try a crank&cam shaft position sensors

SOURCE: 2008 dodge nitro change oil light how to turn off ...

Directions are in the book, but you would put the key in and turn it all the way, just don't start engine. Pump gas pedal all the way to the floor 3 times slowly, but it has to be with 10 seconds. Turn key off and when you start again, oil changed chime and warning should not be on. If it is, try again.

SOURCE: need firing order on 2008 dodge nitro 3.7

V6 1 - 6 - 5 - 4 - 3 - 2

Slant six 1-5-3-6-2-4\

hope this helps.

,Vinny

Stephen

• 21873 Answers
• Posted on Apr 14, 2013

SOURCE: firing order for dodge nitro 08

Should be the same as a Dakota.
The firing order is 1-6-5-4-3-2
The odd cylinders are on the driver side with number 2 being the front cylinder on the passenger side.

Hammer Time

• 884 Answers
• Posted on Aug 18, 2013

SOURCE: Anyone have the firing order diagram for a 2011

Here ya go
Each individual spark plug is located under each ignition coil. Each individual ignition coil must be removed to gain access to each spark plug See: Ignition Coil\Service and Repair\Ignition Coil - Removal

1. Remove necessary air filter tubing at throttle body.
2. Prior to removing ignition coil, spray compressed air around coil base at cylinder head.
3. Prior to removing spark plug, spray compressed air into cylinder head opening. This will help prevent foreign material from entering combustion chamber.
4. Remove spark plug from cylinder head using a quality socket with a rubber or foam insert. Also check condition of ignition coil O-ring and replace as necessary.
5. Inspect spark plug condition

Testimonial: "Thank you, this helped, unfortuantely didn't fix my problem. Went to dealership, there was a mass of problems...thank god for warranties! Thanks again!"