Removal of dashboard assembly for 2002 volkswagen beetle

If your Beetle is a "Turbo S", the whole front clip (bumper facia) has to come off.

For all other Beetle models:
Remove the screw cap at the rear of the front turn/marker lense.
Remove the screw
Pull the lamp assembly forward
Disconnect the electrical connector
Twist the lamp socket to remove it from the lamp assembly
Remove the bulb
Reverse procedure to install

The fuse panel on 2002 VW Beetle Turbo is located behind a plastic cover on the driver's side end panel of the dashboard, door open. The fuse no.# 1 - 10A (red colour) is for cigarrete lighter. See pictures below:




/>

The fuse panel on 2002 VW Beetle is located behind a plastic cover on the driver's side end panel of the dashboard, door open. See pictures below:




The fuse panel diagram:


Please do rate my response. Thanks!

The fuse panel on 2002 VW Beetle is located behind a plastic cover on the driver's side end panel of the dashboard, door open. See pictures below:





The fuse panel diagram:


Please do rate my response. Thanks!

The fuse panel on 2002 VW Beetle is located behind a plastic cover on the driver's side end panel of the dashboard, door open. See pictures below:




The fuse panel diagram:


Please do rate my response. Thanks!

You didn't specify front or rear so here goes. with ignition key off..... front turn/marker light, remove the screw cover in the lens assembly. remove the screw. Pull the lens assembly out forward. Change bulb and reverse process. If it is the side marker on the front quarter panel it is a little more envolved but you shouldnt have a problem doing it. I can walk you through it .let me know how it goes.

Hope this helps! Please don't forget to rate. Thanks!

Removal & Installation

1. Insert a hex wrench into the headlight lock and turn it clockwise 180°.
   
2. Turn the wrench back 90°
   

Headlamp lock—New Beetle



Push the retainer tab to remove the headlight—New Beetle


3. Push the retainer tab and remove the headlight assembly. It will unplug from the connector automatically.

4. Installation is the reverse of removal. Insert the assembly carefully to make sure the connector engages properly.

hi..if you look at the portion of the lense that is closest to the
wheel,you will see a small tab.If you remove it gently,the screw
behind will be revealed.Loosen the screw and the assembly will
come out.
try this out..
thank u..
kindly rate my response..

where is the break light switch on a vw bettle

The foul smell is coming from too much eating sweet yum.