Cars & Trucks Logo

Related Topics:

Paul J Posted on Nov 26, 2013
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Vapor recovery I have a 2008 dodge ram 1500 pickup with a 3.7L ingine. I'm pretty sure the vapor recovery valve is the problem with my gas tank over-flowing when filling up. Where is the the vapor canister filter located and how much do they cost to replace? Thank you in advance. Paul J.

1 Answer

John

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

  • Dodge Master 794 Answers
  • Posted on Nov 26, 2013
 John
Dodge Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

Joined: Oct 01, 2009
Answers
794
Questions
1
Helped
290606
Points
3169

I came across this service bulletin that you will find helpful- I do believe the VCF is above the fuel tank; but if you call any diy auto parts store like NAPA, AutoZone, Pep Boys, etc.or even the parts department at Dodge, for pricing, they'll tell you exactly where it is located and they may even print out the schematic for you. Best wishes on your project. BTW, did you're "check engine" light go on? Did you get an OBD-II fault reading? Or fail an emissions test? Just curious for my own knowledge.


THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 14-001-09, DATED
APRIL 15, 2009, WHICH SHOULD BE REMOVED FROM YOUR FILES. THIS IS A
COMPLETE REVISION AND NO ASTERISKS HAVE BEEN USED TO HIGHLIGHT
REVISIONS.
SUBJECT: Hard To Fill With Fuel Or Fuel Nozzle Shuts Off Repeatedly MODELS: 2004 -2008 (CS) Pacifica
2009 (DS) Ram Truck (1500)
2007 - 2009 (DH) Ram Truck (1500/2500 Pick Up)
2004 - 2009 (DR) Ram Truck (1500 / 2500 Pick Up)
2005 - 2009 (HB) Durango
2007 - 2009 (HG) Aspen
2005 - 2009 (ND) Dakota
2009 (JC) Journey
2007 - 2009 (JK) Wrangler
2007 - 2009 (J1) Sebring (China CKD)
2007 - 2009 (JS) Sebring/Sebring Convertible/Avenger
2006 - 2009 (K1) Cherokee (CKD)
2007 - 2009 (KA) Nitro
2008 - 2009 (KK) Liberty
2008 - 2009 (KK) Cherokee (International Markets)
2005 - 2007 (KJ) Liberty
2005 - 2007 (KJ) Cherokee (International Markets)
2005 - 2009 (LE) 300C/300C Touring (International Markets)
2005 - 2009 (LX) 300/Magnum/Charger
2007 (L2) 300 (China)
2008 - 2009 (LC) Challenger
2004 - 2009 (PT) Chrysler PT Cruiser NUMBER: 14-001-09 REV. A GROUP: Fuel DATE: September 1, 2009 2007 (R2) Caravan/Voyager (CKD)
2005 - 2007 (RG) Chrysler Voyager (International Markets)
2003 - 2007 (RS) Town & Country/Caravan/Voyager
2008 - 2009 (RT) Town & Country/Grand Caravan
2008 - 2009 (RT) Town & Country/Grand Voyager (International
Markets)
2005 - 2006 (TJ) Wrangler
2005 - 2009 (WH) Grand Cherokee (International Markets)
2005 - 2009 (WK) Grand Cherokee
2006 - 2009 (XH) Commander (International Markets)
2006 - 2009 (XK) Commander NOTE: This bulletin applies to all vehicles equipped with a gasoline engine.

DISCUSSION:
Customer may report that the vehicle is hard to fill with fuel or that the fuel pump nozzle
shuts off repeatedly while trying to fill vehicle.
This customer complaint can occur due to a number of different causes. The fuel tank is
the least likely cause of this condition. The following Diagnostic procedure can be used to
diagnose the issues.

DIAGNOSIS:
1. Is the vehicle a LX/LE/LC/L2?
a. Yes >> proceed to Step #2
b. No >> proceed to Step #4
2. Idle the vehicle 60 to 90 seconds upon stopping.
3. Does tank refill properly?
a. No >> proceed to Step #4
b. Yes >> Inform the customer to idle the vehicle for 60 to 90 seconds upon stopping if
vehicle was driven aggressively. This is due to the fact that on the LX/LE/LC/L2 the
fuel tank is a unique saddle tank design and needs 30 to 60 seconds while the
engine is running to level the fuel in both half's of the fuel tank. Allowing the vehicle
to idle for this amount of time will let the fuel pump transfer fuel to the left side tank,
opening the control valve and allowing normal fuel filling.
4. Disconnect the vapor recirculation tube at the fuel tank.
5. Attempt to refill fuel tank.
6. Does tank refill properly?
a. Yes >> Proceed to Step #7
b. No>> Proceed to Step #11.
7. Reconnect the vapor recirculation tube at the fuel tank.
8. Disconnect the other end of the vapor recirculation tube at the fuel filler tube.
9. Attempt to refill fuel tank.
10. Does tank refill properly?
a. Yes >> Replace fuel filler tube.
b. No >> Replace the vapor recirculation tube.
11. Disconnect the control valve to EVAP canister tube at the fuel tank.
14-001-09 REV. A -2-
12. Reconnect the vapor recirculation tube at the fuel tank.
13. Does tank refill properly?
a. No >> Replace Fuel Tank.
b. Yes >> Proceed to Step #14.
14. Reconnect the control valve to EVAP canister tube at the fuel tank.
15. Disconnect the control valve to EVAP canister tube at the EVAP canister.
16. Attempt to refill fuel tank.
17. Does tank refill properly?
a. Yes >> Blockage is in the EVAP Canister, or ESIM, or Clean air hose (ESIM vent
hose), or filter. Diagnose appropriately.
b. No >> Replace the control valve to EVAP canister tube.

POLICY:
Information Only
-3- 14-001-09 REV. A

2 Related Answers

Anonymous

  • 548 Answers
  • Posted on Aug 22, 2009

SOURCE: trying to find the cab filter 04 dodge ram pickup

everything i know about the truck indicates they dont have one

Ad
emissionwiz

Marvin

  • 85242 Answers
  • Posted on Sep 20, 2012

SOURCE: gas tank not filling when filling the gas tank the

There is a fuel vapor recovery device inside the tank that affects fill rate if it malfunctions, it takes the dealer to diagnose it and only the dealer has the parts to fix it.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Which one of the lobes on the cam is my intake valve?

It goes intake, exhaust from front to back as best I can tell. Look at the picture.
26281999-fa2g0hiogkliwezdqhsjwyqa-5-0.jpg
0helpful
1answer

Why does my dodge ram 1500 2008 die after tank topped off; starts right up

cause it needs to build pressure in the tank before it can flow. when the tank is topped off theres too much fluid to build pressure then a little bit for the fluid to make its way to the fuel rail to make room for pressure to build
1helpful
1answer

2008 dodge hemi quit running. Fuel pressure 60 psi, good spark, and had po340 cms sensor code. Replaced sensor, same code. Did a compression test, #5 #6 #7 #8 had zero compression. #4 had 30 psi. I am...

Code340 means the computer is not getting a signal from the cam sensor for one bank. Since you replaced the sensor, and given the fact one side has no compression, it could be that there is no signal because that cam is not turning.
0helpful
1answer

Gas tank not filling when filling the gas tank the pump keeps kicking off every $1-2. It is like the tank is vapor locking. What is the problem and how do i fix it. It's on a 2008 dodge ram 1500

There is a fuel vapor recovery device inside the tank that affects fill rate if it malfunctions, it takes the dealer to diagnose it and only the dealer has the parts to fix it.
0helpful
1answer

04 dodge ram pickup has code po 456 what is this code? 04 dodge ram 1500 5.7 engine gas mileage has gotten worse.

Small leak in evaporative emissions system. Basically takes fuel vapors and recirculates them back to engine to be burned rather than vented into the atmosphere.One common cause of light on dash is faulty/dirty gas cap seal. Did you add fuel just before light came on? Otherwise a small leak at a hose etc., in system, as well as faulty purge system may also cause it.
6helpful
1answer

I have a 03 dodge ram 1500 and got the codes p0440 and p0441. changed gas cap. where are all the parts located

P0441 - Evaporative Emission Control System Incorrect Purge Flow The "EVAP purge flow" faults are issues between the carbon cannister and the intake. The EVAP leak detection generally concerns the fuel tank to carbon cannister plumbing. A little background. The EVAP or evaporative emission system is a control system to keep vapors from evaporation in the fuel tank from getting into the atmosphere. The fuel tank is not vented, but rather the vapors are piped to the carbon cannister (usually located behind the pass. side front wheel) where the charcoal element absorbs the vapor. This is actually a vapor "storage" device. Under certain engine operating conditions, the ECU activates the Cannister Purge Valve (N80) which opens and allows the engine vacuum to **** the fuel vapors back out of the carbon cannister. This purges the vapor, allowing the cannister to absorb more vapor. This evap system has been on vehicles since the '70s. As part of the OBDII standard effective for 1996 cars and newer, it was mandated that leaks in the systems must be detected and reported as a fault which will set the Check Engine Light (CEL). To detect leaks, the system is pressurized by a pump so that leaks can be detected by a lack of appropriate pressure in the system. If there is a leak, such as a cracked vent hose, loose (or leaky) gas cap, poorly installed or defective O-rings on the fuel level senders on the fuel tank, etc. a code will be set. On the cannister to intake side, leaks are detected by deviations in the idle control system. If you have leaks in the lines from the carbon cannister to the intake, intake leaks, a defective purge valve, etc you will often get purge flow faults. My first recommendation is to closely inspect all the small vacuum lines connected to the intake manifold. The corrugated plastic lines are often the culprits, as well as the fabricate covered vacuum lines. Also consider replacing the gas cap.
3helpful
1answer

2003 4x4 Dodge ram 5.7 hemi - Where is the fuel filter located?

The fuel filter is tied in with the fuel pump in the gas tank:)
0helpful
2answers

Where do i star to find a evap leak on my 02 dodge ram 1500 pickup no 4x4

You can start with a smoke test of the fuel system, most problems are caused by a bad purge solenoid.
2helpful
1answer

2006 jeep liberty will not take gas keeps clicking off gas pump. 3rd time at dealer. dealer has no idea what's wrong

The ORVR (On-Board Refueling Vapor Recovery) system consists of a unique fuel tank, flow management valve, fluid control valve, one-way check valve and vapor canister.

The ORVR (On-Board Refueling Vapor Recovery) system is used to remove excess fuel tank vapors. This is done while the vehicle is being refueled..

Fuel flowing into the fuel filler tube (approx. 1 inches I.D.) creates an aspiration effect drawing air into the fuel fill tube. During refueling, the fuel tank is vented to the EVAP canister to capture escaping vapors. With air flowing into the filler tube, there are no fuel vapors escaping to the atmosphere. Once the refueling vapors are captured by the EVAP canister, the vehicle's computer controlled purge system draws vapor out of the canister for the engine to burn. The vapor flow is metered by the purge solenoid so that there is no, or minimal impact on driveability or tailpipe emissions.

As fuel starts to flow through the fuel fill tube, it opens the normally closed check valve and enters the fuel tank. Vapor or air is expelled from the tank through the control valve and on to the vapor canister. Vapor is absorbed in the EVAP canister until vapor flow in the lines stops. This stoppage occurs following fuel shut-off, or by having the fuel level in the tank rise high enough to close the control valve. This control valve contains a float that rises to seal the large diameter vent path to the EVAP canister. At this point in the refueling process, fuel tank pressure increases, the check valve closes (preventing liquid fuel from spiting back at the operator), and fuel then rises up the fuel filler tube to shut off the dispensing nozzle.
Not finding what you are looking for?

1,477 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...