Heater fan doesnt work a/c doesnt work
SOURCE: Oil for Ford 350 engine
Hi flacurias, the 351W typically holds 5 to 6 litres including the filter based on stock sump depth, add 5l and start your engine,run for 1/2 minute or so and check the oil if any oil is still needed it will be a small amount,hope this helps good luck to you
SOURCE: 1989 ford f350 a/c heater fan only runs on high
When your heater only works on high it is usually
the resistor unit in the heater passage housing. Look for wires ( about 4or 5 wires ) attached to the
plastic heater housing under the dash. It should
have a screw or two holding it to the housing. Pull
it out and you will see several wire coils. If they are melted or broken then thats the problem. On any switch position except high the power goes through these resistors to slow the fan down. Good luck. Neil W.
SOURCE: 2006 ford f350 heater fan only works on high or
your blower motor resistor is gone if it only works on hi and low. You'll find it on the blowermotor itself there will be wires going into it and 2 screws holding it in place. when you pull it out it will be a ling square looking flat card
40 views
Usually answered in minutes!
×