Does a dodge ram 1500 have a cam or crank censor?

The two best sites

1998 Dodge Ram Pickup Car Stereo Wire Colors and Locations

https://www.the12volt.com > installbay > stereodetail
1998 Dodge Ram Pickup Stereo Wiring ; Right Front (-), Dark Blue/Red ; Rear Speakers, 5 1/4" Side Panels ; Left Rear (+), Brown/Yellow ; Left Rear (-), Brown/Light ...

1998 Dodge Ram 1500 Radio Wiring Chart - MODIFIEDLIFE

https://www.modifiedlife.com > 1998-dodge-ram-1500...
Our 1998 Dodge Ram 1500 radio wiring diagram shows you all the radio wire colors and what they do. Table of Contents. 1998 Dodge Ram 1500 Radio Wiring Diagram ...

unlikely unless on of the loose bolts is the ground point for the battery
run the fault codes
could be crank or cam position sensors from bad harness connections

Dodge

get your car fix right now

Kind of sounds to me like you have an o2 sensor problem.

You probably have a bad ignition coil. Which engine is in this truck? 3.7, 4.7, 5.7 or hemi

check engine light and code P1391 crank or cam position sensor

The above can cause rough idle on the Dodge Ram 1500 5.2L V8 Engine.

Can try to replace the sensor, but verify that the wires are ok first.

CAMSHAFT POSITION SENSOR 2001 Dodge Truck RAM 1500 1/2 ton 2WD 5.9L SFI 8cyl The Camshaft Position Sensor is located: Under hood, center, upper engine area, rear of intake manifold, mounted in distributor

If this is helpful.Please leave ositive Feedback. Thanks, SnugglePants

I WOULD SAY IT IS THE COMPUTER {BRAIN} THAT IS WHAT SENDS THE FIREING ORDER AND VOLTAGE AND SETS THE TIMEING SPECK I WOULD SAY CHECK THE COMP

there is also a crank sensor that can keep it from sparking. are you getting voltage to the coil