1995 acura legand fan relay location

SOURCE: My 2000 lincoln ls cooling fan will not turn on.

Radiator cooling fan is not electric, it is driven by a silly hydraulic pump which is located low on the passenger side of the engine above the alternator. All 2000-2002 LS's have this system. Most likely either the motor or pump has failed.

Testimonial: "good advice"

SOURCE: Main relay location

The main relay is located behind left side of the dash and above and behind the fusebox and above the hood release.

rate this solution fixya.

Diagram below:-

Acura Main Relay location and removal procedures.
Integra EFI Main Relay for:

• Honda Civic/CRX/del Sol 1984-1995
• 1986-89 INTEGRA
• 1990-93 INTEGRA #39400-SH3-003 RELAY (RZ-0063)
• 1986-90 LEGEND #39400-SH3-003 RELAY (RZ-0063) (RZ-0046)
• 1991-93 LEGEND (rz-0105)
• VIGOR (behind the left front kick panel)

The main relay is located behind left side of the dash and above and behind the fusebox and above the hood release. The First generation Legend main relay location is between the steering column and the fuse box. It's deep in there. There was a little difficulty drawing the relay so it's actually very deep in there. There is a device (a relay) blocking the main relay. You will need to remove it to get a view of the main relay. The removal procedure is the about the same as the Accord's procedure.


Legend, 96-98 Acura TL main relay Acura Integra 98-01 main relay location:

Locating the main relay using your ears and fingers:
Steps:

1. Turn the ignition to ON. You should hear two clicks (a thousand of a second apart) under the left or right side of the dash board. One click is for the ECU/Injectors the other is for the fuel pump. At this moment the check engine light should come on.
2. Listen carefully at the moment the clicks engage (usually somewhere underneath the dashboard.) Reach in and touch the main relay.
3. 2 seconds later you should feel a click if the main relay is at least working or wait until it works. At this moment the check engine light should go out.
4. Turn the ignition to start and you should feel a click, turn engine off you should feel another click.
5. Most main relays should have seven terminals. Please check if the location is already listed below.

How do I get the main relay out?
Steps: See four ways below so you can get it out. First you have to reach high up in there and do all this with one hand and a flashlight.
A. Unbolt the bolt using a 10mm socket (picture A) or
Ab. Unclip the clip from the steel tab and slide it apart (picture A) or
B. Separate the steel tab from the plastic case (picture B) with a large flat screw driver jam and twist between the plastic case and the tab or
C. Disconnect the negative battery terminal. Unclip two clips I pointed with two arrows (picture C, or below) with a small flat head screw driver or with a strong thumb and then yank it out (D.) This is the preferred choice by many. Mechanics prefer choice A and maybe B. See detailed relay circuit photo.

SOURCE: Where is location of cooling fan relay?

Under the hood on the drivers side, just forward of the shock tower, you will see what is called an "under hood fuse center". On the cover you can see the various fuses and relays that are located in the fuse center.
One of those relays is the coolant fan relay. Remove the top cover of the fuse center to gain access to the relay.
Hope this answers your question, good luck.
Regards,

SOURCE: LOCATION FAN RELAY

The relay is under the right front headlamp assembly and bracket. You can access it two ways. Remove the front bumper facia, headlights, and bracket assembly. The grill is part of the facia and the headlight bracket runs all the way across the front. Or you can remove the right headlamp and use a hole saw to cut through the bracket, it is a plastic material.

SOURCE: need to find circuit/relay location for cooling fan. fuse is good, fan motor tested fine. need wiring schematic

where is the cooling fan relay located on a 92 taurus